A while back I asked here about Sound Forge 10 because I was encountering problems with the graphic equalizer that I had successfully used in Sound Forge 9. It was reported that another person had no trouble with the equalizer, but it turned out that the equalizer in Sound Forge Studio worked somewhat differently than in Sound Forge 10 pro. Fortunately, it turns out that the equalizer in Sound Forge 10 pro can be used without too much difficulty. What happens is that the equalizer comes up in what is called "Envelope Mode" where one adjusts the shape of the equalization curve with the mouse. However, there are two other modes, ten band and twenty band that appear to work reasonably with Window-Eyes. So far, the only way I have found to change modes is by clicking on the appropriate mode with the mouse, but this is not too hard to do, and I may still find that there are keystrokes. Also, if I don't, I think the "hot spot" script could be made to do it as well.
I just wanted to pass this on since one might have drawn the conclusion from my question that there was a problem, but really there isn't one at all. Best regards, Steve Jacobson If you reply to this message it will be delivered to the original sender only. If your reply would benefit others on the list and your message is related to GW Micro, then please consider sending your message to [email protected] so the entire list will receive it. GW-Info messages are archived at http://www.gwmicro.com/gwinfo. You can manage your list subscription at http://www.gwmicro.com/listserv.
