Hi Don,
I liked the Braille sense plus's case as well.
It stuck very tight which I liked.
And speaking of your Braille sense plus, how do you like it?
Maybe should have changed the subject for that question, sorry.
Paul
----- Original Message -----
From: "don bishop" <[email protected]
To: <[email protected]
Date sent: Sun, 29 Mar 2009 14:41:54 -0700
Subject: Re: [GWN] CAse issue seems to be resolved
Yes, you have to have the vs positioned just right against the
two front
posts and then press the middle of the back of the vs down
somewhat
firmly and then it should snap into place. It can be a bit
tricky until
you get the hang of it, and it's easy to assume you have it in
place
when it really isn't quite snapped into position. If you get it
snapped
in, I really don't think you should have any further trouble with
it.
While on the subject of cases, as I mentioned the other day, we
just
purchased and received a new braillesense.
The case on that is really nice. It's padded and has velcro
flaps which
will close off all openings such as ports etc., and the case
closes with
a flap on the front closing with velcro. There is also velcro
along the
sides of the case so when you close it, not only is velcro
holding it
shut from the front, but on the sides as well.
It really protects the machine and is the best case I've seen so
far.
Much better than the MPower case and easier to close tightly as
well.
Nice job gw!
Don
----- Original Message -----
From: "Stacey Robinson" <[email protected]
To: <[email protected]
Sent: Sunday, March 29, 2009 2:13 PM
Subject: [GWN] CAse issue seems to be resolved
Hi all,
I had my husband look at my vs case after reading Don's last
message.
I thought maybe one of the medal pieces might have been bent. I
put
it back in the case and there was a deffinit snap. I can't pop
it out
with one hand now. This is deffinitly a good thing.
I would still like to see a more secure design. Maybe a case
sort of
like a braille note case.
The sync braille could stay where it is and there could be some
sort
of slot to slied the vs into. There could be a section that
would go
over the keys with cutouts for the keys and the buttons on the
front
could still be exposed.
I don't know, I'm just thinking as I type.
Have a blessed day,
Stacey Robinson and GEB dog Chesley
Eagleville, Tennessee.
[email protected]
You can also write me at
[email protected]
Check out my website and blog at
www.samobile.net/users/staceylr
__________ NOD32 3973 (20090329) Information __________
This message was checked by NOD32 antivirus system.
http://www.eset.com