Radio Havana Cuba
Dxers Unlimited
Dxers Unlimited’s midweek edition for 8-9 January 2008
By Arnie Coro
Radio amateur CO2KK

Hi amigos radioaficionados around the world and orbiting Planet Earth… 
welcome to the mid week edition of Dxers Unlimited. I am Arnaldo, Arnie, 
Coro, radio amateur CO2KK and as always it’s my pleasure to be able to 
share with you all about seventeen minutes of on the air and on the web 
time,as well as having the opportunity to make the scripts available for 
reading via several e-mail specialized short wave listening and amateur 
radio distribution lists… Among the lists that distribute Dxers 
Unlimited’s scripts are the ODXA, Ontario DX Association, the 
Regenerative Receivers list, as well as the HCDX list…where you can read 
the scripts of the program usually on the same day that it goes on the 
air…  Now here is item one… It’s about the use of one of the classic 
audio output tetrode vacuum tubes in another role, in this case as a 
regenerative detector, something that the 6V6 does with amazing 
performance according to experiments done by several homebrewers , 
including yours truly amigos..

Amazing as it may sound... the 6V6 metal cased tube is an excellent 
choice for a regenerative detector, with the glass version a still  very 
good second choice.
Using screen grid regeneration control in a Hartley ( cathode tap ) type 
of detector , a 6V6 will provide not only very good detection of signals 
up to around 10 megaHertz , but also is absolutely absent from 
microphonics effects that are so annoying.

One pending experiment here at my workshop is to test the miniature type 
tube that is supposedly an exact equivalent to the 6V6, the type 6AQ5, 
just to see if  the results achieved are identical to the excellent 
performance of the 6V6.
Another still pending experiment is to use a 6AG7 ( or Soviet equivalent 
6P9 ) in the same Hartley type regenerative detector and compare results 
both as regards to sensitivity and smoothness of regeneration control.
Using the 6V6 in a regenerative receiver will reduce the tube types to 
just two in a very simple radio, as the second 6V6 ( metal or GT type ) 
will perform as the audio output stage... A better radio will require 
another tube ( maybe a dual triode or an audio pentode ) as the audio 
driver, and in the interest of perfection, one should add a RF amplifier 
stage ahead of the regenerative detector, just to properly isolate the 
detector from the antenna. The line up of such a four tubes 1940's 
decade prototype could then be  6SK7 RF amp, 6V6 detector, 6SJ7 audio 
pre-amp 6V6 audio output stage, and in true GLOWBUGS vacuum tubes 
fashion a 5Y3-G or GT , or a 6X5 dual diode rectifier... Operating the 
power supply at around + 150 volts DC , with
regulated output also at +75 from a VR tube, will complete the receiver 
in full compliance with the 1940's technology...
BUT, you could maybe improve the design a little bit , by using 1N4007's 
in place of the 5Y3-G or GT, Zener diodes for the + 50 to +75 volts for 
the screen voltage supply to the regenerative detector, and also include 
a well regulated 6.0 volts power supply using solid state devices to 
feed the filaments of the 6V6 detector in the first place, and if you
have enough current available, also use DC for the filament of the 6SJ7 
audio preamplifier stage.
BTW, the 6SJ7-6V6 audio amplifier design I use here comes from the 
original Collins 75A1 receiver, also a " Classic" by its own account..
Si amigos, yes my friends , oui mes amis… the 6V6 classic audio output 
pentode offers excellent performance as a regenerative detector, and if 
you have never experimented with this particular type of radio receiver, 
my advice is to try as soon as possible, as you will be absolutely 
amazed with the performance achieved by this unique circuit…
Item two, coming up in just a few seconds, after a short break for 
station ID… I am Arnie Coro your host here at the mid week edition of 
Dxers Unlimited…
……
You are listening to Radio Havana Cuba, the name of the show is Dxers 
Unlimited, and here we attempt to cover all aspects of this wonderful 
hobby you and I enjoy so much: RADIO… Now item two: Emergency 
communications are perhaps the main reason why valuable spectrum space 
is allocated to the amateur radio service… and ham radio operators 
around the world continue to provide much needed emergency links when 
other telecommunictions systems fail for one reason or the other… It may 
be that everyone wants to use the cellphone and that brings the system 
down, or in the case of wired telephone services, the bad weather or an 
earthquake causes severe damages to the cables and exchanges… The 
amateur radio stations can be deployed immediately , and using a car 
battery for power are able to provide very effective links . Among the 
most interesting ways ham radio operators communicate during 
emergencies, the one known as NVIS or Near Vertical Incidence Skywave is 
able to provide short distance links within a range of between 10 and 
500 kilometers around each of the stations, that can be operated at 
rather low power and with very simple antenna systems.
The development of simple, yet effective NVIS antenna systems for 
emergency communications systems continues to attract the attention of 
the more advanced amateur radio operators that are capable of using 
sophisticated antenna modeling software. But the final word about how 
effective a so called “cloud warmer” or more properly Near Vertical 
Incidence Radiator is working only comes after extensive tests and 
evaluations that will favor one antenna over another. Just recently at 
the ANTENNEX Webzine e-mail list a very interesting discussion about 
NVIS antennas for emergency communications was in progress, and as a 
result two very interesting new small sized, yet highly efficient 
antennas for NVIS operations were designed and will now be subjected to 
extensive testing. Both antennas are shorter than a half wave dipole, 
use coaxial cable feedlines and show a very reasonable bandwidth on the 
segment of 40 meters where the designers decided to place the antenna’s 
optimum performance area. One of the antennas uses a single mast or 
support structure that is only about 20 feet or 6 meters high, and the 
other antenna requires two supports or masts , also in the 20 feet or 6 
meters high figure. These types of antennas have to be easily deployed 
by even a single station operator, and they should be ready for field 
installation packed into a very easy to unpack emergency station module. 
As soon as I complete here the tests of the first of these antennas, I 
will make the results available during a special edition of Dxers 
Unlimited, and then also as a dot pdf document that can be sent via 
e-mail to Dxers Unlimited’s listeners around the world that may want to 
try it out also… As I said a while earlier, each and every amateur radio 
operator should have her or his station ready to cope with any possible 
emergencies, and to do so, having a highly efficient antenna for the 
type of communications mode that you foresee using is extremely 
important. A very experienced Cuban radio amateur operator who has 
participated during many hurricane emergency nets is always emphasizing 
to newcomers to the nets that emergency antennas should always be ready 
to be deployed and that one must practice how to install them, because 
when the real emergency comes it’s no time to start to find out how to 
install the antenna, and of course that  your emergency station’s 
module, must be complete with spares and a minimum set of tools so that 
you can do field repairs whenever they are required. NVIS antennas can 
be used on the 160, 80, 60 and 40 meters bands, but typically they are 
used most frequently on 80 meters during the local evening hours and 40 
meters during daytime…
…….

This is Dxers Unlimited’s mid week edition amigos… and here is item 
three of the program… our most popular section of the show… la numero 
uno… You have questions and Arnie answers them… today’s question was 
sent by several listeners that are interested in getting their amateur 
radio stations ready to be able to handle emergencies… The questions 
came from New York, Vermont, Kansas and California, as well as from 
Alabama and Florida. They all want to know more about how to organize a 
portable station that can be quickly deployed in case an emergency 
situation requires the help of the radio amateurs of the community.
Well amigos, in the first place I will recommend having always ready to 
go a 2 meters band 5 Watt output handie talkie, a set of spare batteries 
, a battery charger capable of fast recharging and if possible also of 
providing a slower charging rate, and last but not least , two portable 
antennas. Please notice that I mention two portable antennas, because 
during an emergency situation, you will have no time to fix a broken 
antenna, so you must always include in the emergency station’s module, a 
second antenna as well as at least two lengths of coaxial cable with the 
adequate connectors . Then add, a pair of water bottles, hand tools, an 
LED flashlight and batteries for it, and a first aid kit… If one of the 
two antennas is an easy to assembly 4 or 5 element YAGI, it is much 
better than if the two antennas are of the omnidirectional type, because 
a YAGI BEAM ANTENNA can improve your signal a lot, without requiring 
more power to be drawn from your batteries. Whenever possible, try to 
include also a small solar panel too, so that you can recharge the hand 
held FM 2 meter transceiver batteries using solar energy…In an upcoming 
edition of the program I will provide information on the HF emergency 
station requirements and why it is also very important to keep it ready too…
And now as always at the end of the show, here is Arnie Coro’s Dxers 
Unlimited HF propagation update and forecast… Solar activity is once 
again is expected to be between low and very low for the next several 
days of this week… solar flux is now near 80 units, and the A index was 
at a rather high 16 on Monday due to the effects of a high speed solar 
wind. No sporadic E events expected to occur in the Northern Hemisphere, 
but good chances of nice E skip openings do appear to be possible South 
of the Equator. Best bands for daytime short wave broadcast listening 
are the 25, 19 and 16 meter bands, and nightime reception will be best 
on 49 and 31 meters , with 25 meters also good on North to South 
propagation paths. See you all at the weekend edition of the program 
amigos, and don’t forget to send your comments about the show, radio 
hobby questions and QSL requests to [EMAIL PROTECTED], or VIA AIR MAIL to 
Arnie Coro , Radio Havana Cuba, Havana, Cuba.






---[Start Commercial]---------------------

Order your WRTH 2008:
http://www.hard-core-dx.com/redirect2.php?id=wrth2008
---[End Commercial]-----------------------
________________________________________
Hard-Core-DX mailing list
[email protected]
http://montreal.kotalampi.com/mailman/listinfo/hard-core-dx
http://www.hard-core-dx.com/
_______________________________________________

THE INFORMATION IN THIS ARTICLE IS FREE. It may be copied, distributed
and/or modified under the conditions set down in the Design Science License
published by Michael Stutz at 
http://www.gnu.org/licenses/dsl.html

Reply via email to