10k Ohms per cm? I didn't notice that. Not good. Actually, a friend just asked a very good question: Why not use *solder* as the conductive filament?
> I could design with that as long as everything was slow. I'd assume you > would try to print directly over components, or something like that. > > > > *Drew Van Zandt Cam # US2010035593 (M:Agapito Acosta) * > > > On Thu, May 22, 2014 at 10:56 AM, Jon Evans <[email protected]> wrote: > >> 10k Ohms per cm? Sounds like it would be more useful for ESD shielding >> than drawing circuit traces, although I guess it depends on the >> circuit... >> >> >> On Thu, May 22, 2014 at 10:41 AM, Greg London >> <[email protected]>wrote: >> >>> I just discovered this. >>> >>> conductive filament for 3d printers. >>> "print your own circuit boards" >>> >>> http://www.makergeeks.com/co3dfi.html >>> >>> Cool idea, but if you use heat to melt the filament, >>> I'm not sure how you can solder parts to it. >>> >>> conductive glue? >>> >>> _______________________________________________ >>> Hardwarehacking mailing list >>> [email protected] >>> http://lists.blu.org/mailman/listinfo/hardwarehacking >>> >> >> >> _______________________________________________ >> Hardwarehacking mailing list >> [email protected] >> http://lists.blu.org/mailman/listinfo/hardwarehacking >> >> > -- _______________________________________________ Hardwarehacking mailing list [email protected] http://lists.blu.org/mailman/listinfo/hardwarehacking
