[
https://issues.apache.org/jira/browse/HDFS-17302?page=com.atlassian.jira.plugin.system.issuetabpanels:all-tabpanel
]
Jian Zhang updated HDFS-17302:
------------------------------
Description:
h2. Current shortcomings
[HDFS-14090|https://issues.apache.org/jira/browse/HDFS-14090] provides a
StaticRouterRpcFairnessPolicyController to support configuring different
handlers for different ns. Using the StaticRouterRpcFairnessPolicyController
allows the router to isolate different ns, and the ns with a higher load will
not affect the router's access to the ns with a normal load. But the
StaticRouterRpcFairnessPolicyController still falls short in many ways, such as:
1. *Configuration is inconvenient and error-prone*: When I use
StaticRouterRpcFairnessPolicyController, I first need to know how many handlers
the router has in total, then I have to know how many nameservices the router
currently has, and then carefully calculate how many handlers to allocate to
each ns so that the sum of handlers for all ns will not exceed the total
handlers of the router, and I also need to consider how many handlers to
allocate to each ns to achieve better performance. Therefore, I need to be very
careful when configuring. Even if I configure only one more handler for a
certain ns, the total number is more than the number of handlers owned by the
router, which will also cause the router to fail to start. At this time, I had
to investigate the reason why the router failed to start. After finding the
reason, I had to reconsider the number of handlers for each ns.
2. *Extension ns is not supported*: During the running of the router, if a new
ns is added to the cluster and a mount is added for the ns, but because no
handler is allocated for the ns, the ns cannot be accessed through the router.
We must reconfigure the number of handlers and then refresh the configuration.
At this time, the router can access the ns normally. When we reconfigure the
number of handlers, we have to face disadvantage 1: Configuration is
inconvenient and error-prone.
3. *Waste handlers*: The main purpose of proposing
RouterRpcFairnessPolicyController is to enable the router to access ns with
normal load and not be affected by ns with higher load. First of all, not all
ns have high loads; secondly, ns with high loads do not have high loads 24
hours a day. It may be that only certain time periods, such as 0 to 8 o'clock,
have high loads, and other time periods have normal loads. Assume there are 2
ns, and each ns is allocated half of the number of handlers. Assume that ns1
has many requests from 0 to 14 o'clock, and almost no requests from 14 to 24
o'clock, ns2 has many requests from 12 to 24 o'clock, and almost no requests
from 0 to 14 o'clock; when it is between 0 o'clock and 12 o'clock and between
14 o'clock and 24 o'clock, only one ns has more requests and the other ns has
almost no requests, so we have wasted half of the number of handlers.
4. *Only isolation, no sharing*: The staticRouterRpcFairnessPolicyController
does not support sharing, only isolation. I think isolation is just a means to
improve the performance of router access to normal ns, not the purpose. It is
impossible for all ns in the cluster to have high loads. On the contrary, in
most scenarios, only a few ns in the cluster have high loads, and the loads of
most other ns are normal. For ns with higher load and ns with normal load, we
need to isolate their handlers so that the ns with higher load will not affect
the performance of ns with lower load. However, for nameservices that are also
under normal load, or are under higher load, we do not need to isolate them,
these ns of the same nature can share the handlers of the router; The
performance is better than assigning a fixed number of handlers to each ns,
because each ns can use all the handlers of the router.
h2. New features
Based on the above staticRouterRpcFairnessPolicyController, there are
deficiencies in usage and performance. I provide a new
RouterRpcFairnessPolicyController: ProportionRouterRpcFairnessPolicyController
(maybe with a better name) to solve the above major shortcomings.
1. *More user-friendly configuration* : Supports allocating handlers
proportionally to each ns. For example, we can give ns1 a handler ratio of 0.2,
then ns1 will use 0.2 of the total number of handlers on the router. Using this
method, we do not need to confirm in advance how many handlers the router has.
2. *Sharing* :
was:
[HDFS-14090|https://issues.apache.org/jira/browse/HDFS-14090] provides a
StaticRouterRpcFairnessPolicyController to support configuring different
handlers for different ns. Using the StaticRouterRpcFairnessPolicyController
allows the router to isolate different ns, and the ns with a higher load will
not affect the router's access to the ns with a normal load. But the
StaticRouterRpcFairnessPolicyController still falls short in many ways, such as:
1. *Configuration is inconvenient and error-prone*: When I use
StaticRouterRpcFairnessPolicyController, I first need to know how many handlers
the router has in total, then I have to know how many nameservices the router
currently has, and then carefully calculate how many handlers to allocate to
each ns so that the sum of handlers for all ns will not exceed the total
handlers of the router, and I also need to consider how many handlers to
allocate to each ns to achieve better performance. Therefore, I need to be very
careful when configuring. Even if I configure only one more handler for a
certain ns, the total number is more than the number of handlers owned by the
router, which will also cause the router to fail to start. At this time, I had
to investigate the reason why the router failed to start. After finding the
reason, I had to reconsider the number of handlers for each ns.
2. *Extension ns is not supported*: During the running of the router, if a new
ns is added to the cluster and a mount is added for the ns, but because no
handler is allocated for the ns, the ns cannot be accessed through the router.
We must reconfigure the number of handlers and then refresh the configuration.
At this time, the router can access the ns normally. When we reconfigure the
number of handlers, we have to face disadvantage 1: Configuration is
inconvenient and error-prone.
3. *Waste handlers*: The main purpose of proposing
RouterRpcFairnessPolicyController is to enable the router to access ns with
normal load and not be affected by ns with higher load. First of all, not all
ns have high loads; secondly, ns with high loads do not have high loads 24
hours a day. It may be that only certain time periods, such as 0 to 8 o'clock,
have high loads, and other time periods have normal loads. Assume there are 2
ns, and each ns is allocated half of the number of handlers. Assume that ns1
has many requests from 0 to 14 o'clock, and almost no requests from 14 to 24
o'clock, ns2 has many requests from 12 to 24 o'clock, and almost no requests
from 0 to 14 o'clock; when it is between 0 o'clock and 12 o'clock and between
14 o'clock and 24 o'clock, only one ns has more requests and the other ns has
almost no requests, so we have wasted half of the number of handlers.
4. *Only isolation, no sharing*: The staticRouterRpcFairnessPolicyController
does not support sharing, only isolation. I think isolation is just a means to
improve the performance of router access to normal ns, not the purpose. It is
impossible for all ns in the cluster to have high loads. On the contrary, in
most scenarios, only a few ns in the cluster have high loads, and the loads of
most other ns are normal. For ns with higher load and ns with normal load, we
need to isolate their handlers so that the ns with higher load will not affect
the performance of ns with lower load. However, for nameservices that are also
under normal load, or are under higher load, we do not need to isolate them,
these ns of the same nature can share the handlers of the router; The
performance is better than assigning a fixed number of handlers to each ns,
because each ns can use all the handlers of the router.
Based on the above staticRouterRpcFairnessPolicyController, there are
deficiencies in usage and performance. I provide a new
RouterRpcFairnessPolicyController: ProportionRouterRpcFairnessPolicyController
(maybe with a better name) to solve the above major shortcomings.
1.* More user-friendly configuration*: Supports allocating handlers
proportionally to each ns.
> RBF: ProportionRouterRpcFairnessPolicyController-support proportional
> allocation of semaphores
> ----------------------------------------------------------------------------------------------
>
> Key: HDFS-17302
> URL: https://issues.apache.org/jira/browse/HDFS-17302
> Project: Hadoop HDFS
> Issue Type: New Feature
> Components: rbf
> Reporter: Jian Zhang
> Assignee: Jian Zhang
> Priority: Major
> Labels: pull-request-available
> Attachments: HDFS-17302.001.patch, HDFS-17302.002.patch
>
>
> h2. Current shortcomings
> [HDFS-14090|https://issues.apache.org/jira/browse/HDFS-14090] provides a
> StaticRouterRpcFairnessPolicyController to support configuring different
> handlers for different ns. Using the StaticRouterRpcFairnessPolicyController
> allows the router to isolate different ns, and the ns with a higher load will
> not affect the router's access to the ns with a normal load. But the
> StaticRouterRpcFairnessPolicyController still falls short in many ways, such
> as:
> 1. *Configuration is inconvenient and error-prone*: When I use
> StaticRouterRpcFairnessPolicyController, I first need to know how many
> handlers the router has in total, then I have to know how many nameservices
> the router currently has, and then carefully calculate how many handlers to
> allocate to each ns so that the sum of handlers for all ns will not exceed
> the total handlers of the router, and I also need to consider how many
> handlers to allocate to each ns to achieve better performance. Therefore, I
> need to be very careful when configuring. Even if I configure only one more
> handler for a certain ns, the total number is more than the number of
> handlers owned by the router, which will also cause the router to fail to
> start. At this time, I had to investigate the reason why the router failed to
> start. After finding the reason, I had to reconsider the number of handlers
> for each ns.
> 2. *Extension ns is not supported*: During the running of the router, if a
> new ns is added to the cluster and a mount is added for the ns, but because
> no handler is allocated for the ns, the ns cannot be accessed through the
> router. We must reconfigure the number of handlers and then refresh the
> configuration. At this time, the router can access the ns normally. When we
> reconfigure the number of handlers, we have to face disadvantage 1:
> Configuration is inconvenient and error-prone.
> 3. *Waste handlers*: The main purpose of proposing
> RouterRpcFairnessPolicyController is to enable the router to access ns with
> normal load and not be affected by ns with higher load. First of all, not all
> ns have high loads; secondly, ns with high loads do not have high loads 24
> hours a day. It may be that only certain time periods, such as 0 to 8
> o'clock, have high loads, and other time periods have normal loads. Assume
> there are 2 ns, and each ns is allocated half of the number of handlers.
> Assume that ns1 has many requests from 0 to 14 o'clock, and almost no
> requests from 14 to 24 o'clock, ns2 has many requests from 12 to 24 o'clock,
> and almost no requests from 0 to 14 o'clock; when it is between 0 o'clock and
> 12 o'clock and between 14 o'clock and 24 o'clock, only one ns has more
> requests and the other ns has almost no requests, so we have wasted half of
> the number of handlers.
> 4. *Only isolation, no sharing*: The staticRouterRpcFairnessPolicyController
> does not support sharing, only isolation. I think isolation is just a means
> to improve the performance of router access to normal ns, not the purpose. It
> is impossible for all ns in the cluster to have high loads. On the contrary,
> in most scenarios, only a few ns in the cluster have high loads, and the
> loads of most other ns are normal. For ns with higher load and ns with normal
> load, we need to isolate their handlers so that the ns with higher load will
> not affect the performance of ns with lower load. However, for nameservices
> that are also under normal load, or are under higher load, we do not need to
> isolate them, these ns of the same nature can share the handlers of the
> router; The performance is better than assigning a fixed number of handlers
> to each ns, because each ns can use all the handlers of the router.
> h2. New features
> Based on the above staticRouterRpcFairnessPolicyController, there are
> deficiencies in usage and performance. I provide a new
> RouterRpcFairnessPolicyController:
> ProportionRouterRpcFairnessPolicyController (maybe with a better name) to
> solve the above major shortcomings.
> 1. *More user-friendly configuration* : Supports allocating handlers
> proportionally to each ns. For example, we can give ns1 a handler ratio of
> 0.2, then ns1 will use 0.2 of the total number of handlers on the router.
> Using this method, we do not need to confirm in advance how many handlers the
> router has.
> 2. *Sharing* :
--
This message was sent by Atlassian Jira
(v8.20.10#820010)
---------------------------------------------------------------------
To unsubscribe, e-mail: hdfs-issues-unsubscr...@hadoop.apache.org
For additional commands, e-mail: hdfs-issues-h...@hadoop.apache.org
