I used to use a 4x4 with a little Americlear or Xylene to clean the paraffin off before relabeling. You can then dip or run a little paraffin over it. May not be practical if you have a lot.
Tom McNemar, HT(ASCP) Histology Co-ordinator Licking Memorial Health Systems (740) 348-4163 (740) 348-4166 [email protected] www.LMHealth.org -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Patrick Laurie Sent: Monday, June 24, 2013 12:00 PM To: [email protected] Subject: [Histonet] Block labeling Hi Everyone, What is the best way to label blocks that are already embedded? We have a large control bank that we are trying to relabel and make search able, however, most marking pens don't write well on paraffin covered blocks, even when we scrape them off. Pencils work, not always the most legibly, so I was wondering if there is a clever solution that someone might have found. We've tried putting stickers or labels on the back, but that falls right off. Thanks in advance for any suggestions. -- Patrick Laurie(HT)ASCP QIHC Histology Manager Celligent Diagnostics, LLC 101 East W.T. Harris Blvd | Suite 1212 | Charlotte, NC 28262 Work: 704-970-3300 Cell: 704-266-0869 _______________________________________________ Histonet mailing list [email protected] http://lists.utsouthwestern.edu/mailman/listinfo/histonet This e-mail, including attachments, is intended for the sole use of the individual and/or entity to whom it is addressed, and contains information from Licking Memorial Health Systems which is confidential or privileged. If you are not the intended recipient, nor authorized to receive for the intended recipient, be aware that any disclosure, copying, distribution or use of the contents of this e-mail and attachments is prohibited. If you have received this in error, please advise the sender by reply e-mail and delete the message immediately. You may also contact the LMH Process Improvement Center at 740-348-4641. E-mail transmissions cannot be guaranteed to be secure or error-free as information could be intercepted, corrupted, lost, destroyed, arrive late or incomplete, or contain viruses. The sender therefore does not accept liability for any errors or omissions in the contents of this message, which arise as a result of e-mail transmission. Thank you. _______________________________________________ Histonet mailing list [email protected] http://lists.utsouthwestern.edu/mailman/listinfo/histonet
