I had this same thing happen to me right after a windows update. I used system restore to go back before the update and my choke disappeared. It was 0 before the update. It was up arround 80 afterwards at times, (altho the game didnt play like it, which made it hard to figure out,)it clearly wasnt the rates, which I had not changed. And I tryed various servers, from my own 500 fps to lowly unboosted servers. It would start at nearly 100 and drop almost immediatly to around 20, then go up after I actually started playing. I didnt make the connection at first because it also happen about the time of a steam update. I had even tryed reloading steam, which did nothing. And I had another computer which worked fine on the same connection, but had not been updated, unfortunatly it was a while before I tryed the 2nd computer and figured it out. ----- Original Message ----- From: "doomed999" <[EMAIL PROTECTED]> To: <hlds_linux@list.valvesoftware.com> Sent: Thursday, November 10, 2005 5:47 PM Subject: RE: [hlds_linux] Wierd Choke Problem
Same as yours. -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of [EMAIL PROTECTED] Sent: Thursday, November 10, 2005 4:28 PM To: hlds_linux@list.valvesoftware.com Subject: RE: [hlds_linux] Wierd Choke Problem Aside from your server it would depend on who your colo is. -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of doomed999 Sent: Thursday, November 10, 2005 4:49 PM To: hlds_linux@list.valvesoftware.com Subject: [hlds_linux] Wierd Choke Problem Ok, I am seeing this on both hlds and srcds. I have not seen this problem before (on my servers) and isn't my rates doing it. The rates I have tried rate 30000 cl_update 100 cl_cmd 100 rate 25000 cl_update 80 cl_cmd 80 The best that seems to work is rate 30000 cl_update 50 cl_cmd 50 But there should be no reason I can't run 100 in my eyes. It normally spikes the worst when the bomb goes off and when the round restarts. With source it seems worse spiking up to the 30's with the 50 update rate. Server is running at 66 Tick. HLDS running at default and same thing. It is doing with with as little as one server on a machine. The machine specs are as follows Dual Xeon 3.0 2M cache 2G DDR2 533 ECC Running CentOS 4.1 Fully Burstable 100Mbps Port (Possible problem?) The only thing I can figure at this point is an overloaded network at the datacenter I am colocating through? I am at a complete loss. Please give your input. _______________________________________________ To unsubscribe, edit your list preferences, or view the list archives, please visit: http://list.valvesoftware.com/mailman/listinfo/hlds_linux _______________________________________________ To unsubscribe, edit your list preferences, or view the list archives, please visit: http://list.valvesoftware.com/mailman/listinfo/hlds_linux _______________________________________________ To unsubscribe, edit your list preferences, or view the list archives, please visit: http://list.valvesoftware.com/mailman/listinfo/hlds_linux
_______________________________________________ To unsubscribe, edit your list preferences, or view the list archives, please visit: http://list.valvesoftware.com/mailman/listinfo/hlds_linux