On Fri, 9 Jun 2006 09:15:22 +0200 Eberhard Roloff <[EMAIL PROTECTED]> wrote:
> Hi, > > On Thu, 08 Jun 2006 14:21:54 -0700 > Aaron J Albright <[EMAIL PROTECTED]> wrote: > >and then run this > > command: > > > > snmpwalk -Os -c public -v 1 <IP.OF.PRINTER.HERE> > > 1.3.6.1.4.1.11.2.3.9.1.1.7.0 > > > > What is the result? This will tell us if snmp is working > > correctly. > > This is what I get from the command: > > [EMAIL PROTECTED]:~$ sudo snmpwalk -Os -c public -v 1 192.168.1.3 > 1.3.6.1.4.1.11.2.3.9.1.1.7.0 Password: > enterprises.11.2.3.9.1.1.7.0 = STRING: > "MFG:Hewlett-Packard;CMD:PJL,PML,MLC,POSTSCRIPT,PCLXL,PCL;MDL:HP > LaserJet 3390;CLS:PRINTER;DES:Hewlett-Packard LaserJet > 3390;MEM:MEM=117MB;1284.4DL:4d,4e,1;OPTRAY:250Sheets;COMMENT:RES=1200x1;" > > > regards and may thanks for your help Just to update you on the current status: I tried to install hplip 0.9.11 packages from Debian unstable, but could not get the dependency issues on my kubuntu dapper cleared. So the installed packages were broken and did not work. Then I retried with compiling the hplip source from scratch. The compile worked without a glitch, but after install, I got what I previously had: "Open device failed, will retry in 30sec." in http://localhost:631 Then I ran the snmpwalk command that you suggested and got the same result as reported further up. Lastly I cleaned anything and currently I am using dappers version 0.9.7, where I can run hp-setup successfully and printing via hplip is working but there is no fax support. snmpwalk is still reporting waht I had got. I am slightly doubting whether it was wise (for me) to change to (k)ubuntu 6.06 fairly early, although apart from the stone old hplip packages that come with this freshly released system, I am very happy with the system. Your help is greatly appreciated. regards Eberhard _______________________________________________ HPLIP-Help mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/hplip-help
