According to Bard: > // > I'm having trouble getting my installation of htdig to read all the > // > attributes I've set in the config file. > // > // I'd make sure that you haven't attempted to define the attribute more than > // once. Also, you should make sure that it's picking up the config file you > // expect it to. Remember that htsearch uses the DEFAULT_CONFIG_DIR as it has > // been compiled into the program. > > Thanks for your comments. I'm certain I've only defined the attributes only > once, but I've only defined them in htdig.conf. Should I be looking elsewhere? > > That my config file is being read, but for the above attributes, I'm also > certain about. All my other definitions are picked up and used as I would > expect them to. Also have a look at the "config" input parameter definition in your search form, to make sure htsearch is using "htdig" (for htdig.conf), and not some other .conf file. Look carefully for typos in your search form and config file as well. If all else fails, you may want to post your config file to the list for closer examination by others. -- Gilles R. Detillieux E-mail: <[EMAIL PROTECTED]> Spinal Cord Research Centre WWW: http://www.scrc.umanitoba.ca/~grdetil Dept. Physiology, U. of Manitoba Phone: (204)789-3766 Winnipeg, MB R3E 3J7 (Canada) Fax: (204)789-3930 _______________________________________________ htdig-general mailing list <[EMAIL PROTECTED]> To unsubscribe, send a message to <[EMAIL PROTECTED]> with a subject of unsubscribe FAQ: http://htdig.sourceforge.net/FAQ.html
