Just before I received your message I realized that I had to run ./configure
I did and it told me to run "make" and then "make install". Just trying to figure
that out now. Thanks.
Glenn
P.S. Like I said "I'm new to this" so pardon my ignorance.
ATLE VEKA wrote:
> Glenn,
>
> It sounds like you just copied and moved the compiled over to the new server, am I
>right?
> I am pretty sure you need to recompile it. Also, it's at compile time that you
>specify all the directories in the CONFIG file (generated by ./configure, I believe).
> Since you may not know if the architecture/system of this new server, I strongly
>suggest you recompile it on the new server.
> But, I may be wrong.
>
> -
> Atle
>
> >>> "Glenn J. Rowe" <[EMAIL PROTECTED]> 03/06/00 09:02AM >>>
> Ok - Here I go again... I'm going to show my ignorance one more time.
>
> Someone else originally installed htdig but now I have to move it to a
> new server. The paths on the new server are a little different.
> My path used to be /home/ottawacomputer/htdig and now it is
> /home/occ/htdig
> I have specified the new path in the htdig.conf file but there must be
> more places because when I try and search it says it can't find the
> htdig.conf file.
>
> Also since in the htdig.conf I have the start_url set to be
> `${common_dir}/sites.txt` it is unable to find the list of start pages
> to index. It doesn't know where ${common_dir} is.
>
> ------------------------------------
> To unsubscribe from the htdig mailing list, send a message to
> [EMAIL PROTECTED]
> You will receive a message to confirm this.
------------------------------------
To unsubscribe from the htdig mailing list, send a message to
[EMAIL PROTECTED]
You will receive a message to confirm this.
