AW: [htdig] Fw: & in Titles

[Reich, Stefan]

I'm not quite sure, but I had a similar problem, where a document containing
& comes out of htdig with &amp in the source, so it looked like &amp
in the browser.

First you should check the HTML source of the result file.
If this is your problem too, you can switch this behavior off using
translate_amp: true (check the other translate_ options as well)

I must confess, I don't understand, why this is switched off by default.

Maybe this helps

  Stefan 


-----Urspr�ngliche Nachricht-----
Von: Geoff Hutchison [mailto:[EMAIL PROTECTED]]
Gesendet: Mittwoch, 28. Juni 2000 15:31
An: Roger Salisbury
Cc: [EMAIL PROTECTED]
Betreff: Re: [htdig] Fw: &amp in Titles


At 12:11 PM -0500 6/26/00, Roger Salisbury wrote:
>Sorry, running 3.20b2
>
>  > Is there a way to get the &amp html code to display the "&" from the
>  > titles??

I'm not quite sure I understand what you mean. Do you mean that you 
have '&' characters in your titles that are showing up incorrectly in 
results?

The only correct way to show the '&' character in HTML (like the 
htsearch results) is with the & entity. Using the ampersand 
character alone can confuse some browsers.

--
-Geoff Hutchison
Williams Students Online
http://wso.williams.edu/

------------------------------------
To unsubscribe from the htdig mailing list, send a message to
[EMAIL PROTECTED]
You will receive a message to confirm this.

------------------------------------
To unsubscribe from the htdig mailing list, send a message to
[EMAIL PROTECTED]
You will receive a message to confirm this.