Hello Thomas,

On Tue, 16 Sep 2014 04:37:43 +1000, T. Modes <[email protected]> wrote:

[snip]


unknown argument "--no-ciecam"

So it would seem that --no-ciecam is now hardwired into hugin's enblend
parameters, and multiblend doesn't use or like that parameter.


that's wrong. The only hard-wired parameters are --compression, -f and -w
(if applicable).
--no-ciecam and ----primary-seam-generator=graph-cut you have explicitly
set in your project settings (on the stitcher tab)


Yes, those settings are in the stitcher tab Blender option.
I didn't find any default or editable arguments in the Preferences -> Programs which is where I expected to see such settings. If you say I explicitly set these options, then I guess you are correct, but it's not something that I can remember doing in recent history. So it seems that these settings are saved somewhere, but where? I don't see anything in my .hugin file. Aaaah...it finally dawns, I have been testing a project provided by someone else, and there it is near the end of the .pto file. Well it is a relief to know that the last skerrick of grey matter is still working, at least a little bit, but would be more so if it had dawned much earlier.
Thanks for the help.

Cheers,
--
Regards,
Terry Duell

--
A list of frequently asked questions is available at: 
http://wiki.panotools.org/Hugin_FAQ
--- You received this message because you are subscribed to the Google Groups "hugin and other free panoramic software" group.
To unsubscribe from this group and stop receiving emails from it, send an email 
to [email protected].
To view this discussion on the web visit 
https://groups.google.com/d/msgid/hugin-ptx/op.xl83msnwrs0ygh%40localhost.
For more options, visit https://groups.google.com/d/optout.

Reply via email to