Thanks, Allan..that make sense to me... I checked the jes2 init deck, there's no LINE(nnn) statement...
On Wed, Jan 27, 2010 at 9:48 PM, Staller, Allan <allan.stal...@kbm1.com>wrote: > If you have no lines, why are you issuing the command(s) at all? > Check and see if there are any line(nn) statements in you init deck and > only start/stop that number of lines, or remove the commands entirely if > no line(nn) statements are present. > > I just checked the manual and the range for line(*) is 1-65535. > Since you specified LINE(*) in your command, it will have to check 64K > lines. This is bound to take a while. > > This is most likely not caused by you MASDEF parameters. > > HTH, > > <snip> > We have a Lpar (not in sysplex), every time when we shutdown/warmstart > JES2 > in IPL, we have a command $PLINE(*)/$SLINE(*), we will get: > *$HASP9203 LONG PCE DISPATCH 188 > DURATION-000:00:17.76 PCE-COMM EXIT-NONE JOB ID-NONE > COMMAND-$PLINE(*) > $HASP003 RC=(25),P LINE(*) - NO SELECTABLE DEVICE(S) FOUND > $HASP9301 JES2 MAIN TASK ALERTS CLEARED > I checked, we don't have any LINE defined, why this command would spend > so > much time? Not sure if MASDEF related, > MASDEF DORMANCY=(100,500), > HOLD=0, > LOCKOUT=1000, > </snip> > > ---------------------------------------------------------------------- > For IBM-MAIN subscribe / signoff / archive access instructions, > send email to lists...@bama.ua.edu with the message: GET IBM-MAIN INFO > Search the archives at http://bama.ua.edu/archives/ibm-main.html > -- Cobe Xu Best Regards ----------------------------------------------------------- zOS Performance & Capacity Analyst E2E Performance Analyst Email: cob...@gmail.com ----------------------------------------------------------- ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to lists...@bama.ua.edu with the message: GET IBM-MAIN INFO Search the archives at http://bama.ua.edu/archives/ibm-main.html
