Just issue the UPGRADE command. IIRC FIXCAT support was added to SMP/E around 2008. Your global zone must have been created with a release of SMP/E before that.
-- Tom Marchant On Fri, 29 Mar 2024 21:59:49 +0000, Steely.Mark <steely.m...@ace.aaa.com> wrote: >I recently received this message: GIM58903W SMP/E COULD NOT PROCESS A >++HOLD FIXCAT MCS BECAUSE IT WOULD HAVE MADE A CHANGE TO THE GLOBAL ZONE THAT > > CANNOT BE PROCESSED COMPLETELY BY PRIOR LEVELS OF SMP/E. USE THE > UPGRADE COMMAND TO ALLOW SMP/E TO MAKE > > SUCH CHANGES. > >The message says you can execute the upgrade command. ( I am not sure if I >can do that without having some type of maintenance applied) > >It has been a while since I upgraded SMP/e independently of a Service Pack or >some other type of installation. > >I thought I would just install the new release of SMP/e - for some reason I >can't find it on ShopzSeries. > >I have tried to look all over the internet for the answer, but I always gets >hits on installing other products using SMP/e. > >We are currently at SMP/E 37.13 >Our SMP/E is 2.4 FMID - HMP1K00. > >What should I do ? ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to lists...@listserv.ua.edu with the message: INFO IBM-MAIN