I can confirm this. IPL is required. Last October at GSE I suggested to Mark Nelson (of RACF development) that perhaps there should be a SET RACF command similar to a SET SMF command. The answer was that such a project would be highly complex. I don't think I am holding my breath for such a solution.
Lennie -----Original Message----- From: IBM Mainframe Discussion List <[email protected]> On Behalf Of Gibney, Dave Sent: 03 August 2024 09:25 To: [email protected] Subject: Re: parmlib IRRPRM00 and ICHRDSNT The RACF STC is there to accept and perform console commands. It is not SAF/RACF security processing. Pretty sure it still takes an IPL to change ICHRDSNT definitions > -----Original Message----- > From: IBM Mainframe Discussion List <[email protected]> On > Behalf Of Colin Paice > Sent: Saturday, August 3, 2024 1:00 AM > To: [email protected] > Subject: parmlib IRRPRM00 and ICHRDSNT > > [EXTERNAL EMAIL] > > I've moved from having my RACF definitions in load module ICHRDSNT > into parmlib member IRRPRM00, and use RACF=00 in ieasysxx . This works fine. > > If I change this member, stop RACF and restart RACF it uses the > definitions in place at IPL time - not my updated definitions. > > I can't find a z/OS command to refresh this, or change the RACF= option. > Does anyone know what I need to do to use the updated member? > > Colin > > ---------------------------------------------------------------------- > For IBM-MAIN subscribe / signoff / archive access instructions, send > email to [email protected] with the message: INFO IBM-MAIN ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN
