Well, you could try the SETSMF command.
>From the MVS System Commands manual. SETSMF parameter(value[,value]...) "In contrast to the SET command, which allows an installation to specify a different SMFPRMxx parmlib member or restart SMF, the SETSMF command allows an installation to add a SUBPARM parameter or replace any previously-specified parameter in the active SMF parmlib member except the ACTIVE, PROMPT, SID, EXITS or AUTHSETSMF parameters. The SETSMF command cannot add a parameter to the active SMF parmlib member. To avoid possible confusion with the SET SMF command, use the abbreviation SS for the SETSMF command." Also, I believe there is a way to see which SMFPRM members are in use. Down side it will not tell you which PARMLIB the members are in. You could use the D IPLINFO command. I've used it in the past to see what members are in use for different PARMLIB members "Use the DISPLAY IPLINFO,sysparm command to display the value specified or defaulted for any system parameter that is allowed within IEASYSxx. The output is message IEE255I." Paul -----Original Message----- From: IBM Mainframe Discussion List <[email protected]> On Behalf Of Phil Smith III Sent: Sunday, May 18, 2025 6:24 PM To: [email protected] Subject: Re: Disable user timeout via JWT? Right you are. I would have bet money I saw it in there, but obviously I was wrong. See my other note...I think we've found the culprit, thanks to all y'all's patient suggestions! Last question is how to activate the change, and I'm betting it'll then be cured... -----Original Message----- From: IBM Mainframe Discussion List <[email protected]> On Behalf Of Jeremy Nicoll Sent: Sunday, May 18, 2025 7:19 PM To: [email protected] Subject: Re: Disable user timeout via JWT? On Sun, 18 May 2025, at 20:55, Phil Smith III wrote: > But I just checked and all the members have JWT(2400). As Jay said, not in the D SMF,O output you show ... which also does not mention IEFUTL. ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN
