After following Les' recommendations for installing and customizing the RMS component of DFSMS/VM, review and follow the instructions in the VM:Tape System Administrator's Guide; Appendix D, IBM Tape Library Data Server.
Those steps will guide you to: --> Update your VMTAPE CONFIG file --> Update the DFSMS/VM DGTAUTH DATA file --> Ensure that the VM:Tape virtual machine is LINKED and ACCESSED to the DFSMS "run disk" (usually the DFSMS 1B5 minidisk) --> Issue a VMTAPE START RMS command --> Issue a VMTAPE SET LOCATION command if needed If you have more questions, please call CA's VM Customer Support ... JR (Steven) Imler CA Senior Software Engineer Tel: +1 703 708 3479 Fax: +1 703 708 3267 [EMAIL PROTECTED] -----Original Message----- From: The IBM z/VM Operating System [mailto:[EMAIL PROTECTED] On Behalf Of Les Geer (607-429-3580) Sent: Thursday, May 04, 2006 10:52 PM To: IBMVM@LISTSERV.UARK.EDU Subject: VM:Tape, DFSMS/VM and RMS >I'm at a point where I'm trying to figure out what specific pieces are >needed to get the items listed in the subject line above >and a 3494 to work together. This is the first time I've worked with a >3494, DFSMS/VM and RMS. I've read some of the manuals, >both IBM and CA, and am a little confused as to what needs to be config'd >on each of the products listed.. > You will want to install the RMS component of DFSMS/VM (RMSONLY) then follow setup information in chapter 2 of the RMS User's Guide. Best Regards, Les Geer IBM z/VM and Linux Development