reran service and put2prod. the date on CPLOAD MODULE is now 3/27/07. :)
> -----Original Message----- > From: The IBM z/VM Operating System > [mailto:[EMAIL PROTECTED] On Behalf Of Marcy Cortes > Sent: Thursday, May 17, 2007 3:15 PM > To: IBMVM@LISTSERV.UARK.EDU > Subject: Re: different levels of CP and CMS after put2prod > for z/VM 5.2 > > > Try just "PUT2PROD CP" and see if you get a new one out > there. Look also to see if the new one is on your 493/193 disk. > > > Marcy Cortes > > > "This message may contain confidential and/or privileged > information. If you are not the addressee or authorized to > receive this for the addressee, you must not use, copy, > disclose, or take any action based on this message or any > information herein. If you have received this message in > error, please advise the sender immediately by reply e-mail > and delete this message. Thank you for your cooperation." > > > -----Original Message----- > From: The IBM z/VM Operating System > [mailto:[EMAIL PROTECTED] On Behalf Of Little, Chris > Sent: Thursday, May 17, 2007 1:07 PM > To: IBMVM@LISTSERV.UARK.EDU > Subject: Re: [IBMVM] different levels of CP and CMS after > put2prod for z/VM > 5.2 > > Nope: > > CPLOAD MODULE Z1 V 65535 191 3022 10/23/05 > 11:53:04 > > Searched for CPLOAD in $VMFP2P $MSGLOG but it doesn't even > show, but perhaps that isn't where I would find it? > > > -----Original Message----- > > From: The IBM z/VM Operating System > > [mailto:[EMAIL PROTECTED] On Behalf Of Eric Schadow > > Sent: Thursday, May 17, 2007 2:42 PM > > To: IBMVM@LISTSERV.UARK.EDU > > Subject: Re: different levels of CP and CMS after put2prod for z/VM > > 5.2 > > > > Chris > > > > Check if the CPLOAD MODULE on the maint CF1 is from today... > > > > You may have encountered an error on the CP build > > > > eric > > > > > > > > > > Eric Schadow > > Mainframe Technical Support > > www.davisvision.com > > > > > > > > > > -------------------------------------------------------------- > > ---------- > > The information contained in this communication is intended > only for > > the use of the recipient(s) named above. It may contain information > > that is privileged or confidential, and may be protected by State > > and/or Federal Regulations. If the reader of this message > is not the > > intended recipient, you are hereby notified that any dissemination, > > distribution, or copying of this communication, or any of its > > contents, is strictly prohibited. If you have received this > > communication in error, please return it to the sender > immediately and > > delete the original message and any copy of it from your computer > > system. If you have any questions concerning this message, please > > contact the sender. > > -------------------------------------------------------------- > > ---------- > > >