Thanks Kris. I have done this for page packs but not for spool so I wanted to be sure of this. I actually saved a couple of RESERVED slots right below my current spool definition so that I can group them together. I know you cannot move the existing one without ramifications.
Thank You, Terry Martin Lockheed Martin - Information Technology z/OS & z/VM Systems - Performance and Tuning Cell - 443 632-4191 Work - 410 786-0386 [EMAIL PROTECTED] -----Original Message----- From: The IBM z/VM Operating System [mailto:[EMAIL PROTECTED] On Behalf Of Kris Buelens Sent: Thursday, October 30, 2008 2:45 AM To: IBMVM@LISTSERV.UARK.EDU Subject: Re: Adding spool volume dynamically -Use ICKDSF (or CPFMTXA) to format a new pack, allocate (part of) it as SPOL -Use Q CPOWNED to find a slot number that is RESERVED -Add the volume in the CP Owned list in SYSTEM CONFIG, use the slot number you found in Q CPOWNED. If the number of RESERVED slots os low, add a few (these new reserved slots become available only after IPL) -Run CPSYNTAX to verify SYSTEM CONFIG -Issue DEFINE CPOWNED, using the same slot number as above -ATTACH the new volume to SYSTEM 2008/10/29 Martin, Terry R. (CMS/CTR) (CTR) <[EMAIL PROTECTED]>: > Hi > > > > I know this has probably been asked before can/how do you add a SPOOL volume > dynamically and safely! > > > > Thank You, > > > > Terry Martin > > Lockheed Martin - Information Technology > > z/OS & z/VM Systems - Performance and Tuning > > Cell - 443 632-4191 > > Work - 410 786-0386 > > [EMAIL PROTECTED] > > -- Kris Buelens, IBM Belgium, VM customer support