Correct. One addition: Giles Heron from Tellabs is already working on IPv6 part of this draft.
/himanshu > -----Original Message----- > From: Shane Amante [mailto:[EMAIL PROTECTED] > Sent: Thursday, August 17, 2006 9:29 AM > To: Pekka Savola > Cc: l2vpn@ietf.org; ietf@ietf.org > Subject: Re: L2VPNs must not be IP(v4)-only > > > Pekka, > > This topic has come up in the past -- the last time I recall > it being a > significant issue was IETF 63 in Paris, France. On multiple > occasions > since then we have asked for volunteers with IPv6 expertise to help > complete the IPv6 bits of this I-D. Unfortunately, we have gotten > little to no response. Do you wish to help out with this? > Or, can you > provide a pointer to folks in the IPv6 world that can take a look at > this doc and help out? > > Thanks, > > -shane > > > Pekka Savola wrote: > > On Wed, 16 Aug 2006, [EMAIL PROTECTED] wrote: > >> A New Internet-Draft is available from the on-line Internet-Drafts > >> directories. > >> This draft is a work item of the Layer 2 Virtual Private Networks > >> Working Group of the IETF. > >> > >> Title : ARP Mediation for IP Interworking of Layer 2 VPN > >> Author(s) : H. Shah, et al. > >> Filename : draft-ietf-l2vpn-arp-mediation-07.txt > >> Pages : 21 > >> Date : 2006-8-16 > > ... > >> The VPWS service [L2VPN-FRM] provides point-to-point connections > >> between pairs of Customer Edge (CE) devices. It does so by > >> binding two Attachment Circuits (each connecting a CE device > >> with a Provider Edge, PE, device) to a pseudowire (connecting > >> the two PEs). In general, the Attachment Circuits must be of > >> the same technology (e.g., both Ethernet, both ATM), and the > >> pseudowire must carry the frames of that technology. However, > >> if it is known that the frames' payload consists solely of IP > >> datagrams, it is possible to provide a point-to-point connection > >> in which the pseudowire connects Attachment Circuits of > >> different technologies. This requires the PEs to perform a > >> function known as "ARP Mediation". ARP Mediation refers to the > >> process of resolving Layer 2 addresses when different resolution > >> protocols are used on either Attachment Circuit. The methods > >> described in this document are applicable even when the CEs run > >> a routing protocol between them, as long as the routing protocol > >> runs over IP. > > > > > > The document says, > > > > 10. IPV6 Considerations > > > > The support for IPV6 is not addressed in this draft and is for > > future study. > > > > This needs to be addressed throughout the document. > > > > The whole point of L2VPNs (IMHO) is that it's agnostic of > what protocols > > users run above L2. Users depend on a transparent L2 > service model and > > this model breaks that assumption. > > > > _______________________________________________ Ietf mailing list Ietf@ietf.org https://www1.ietf.org/mailman/listinfo/ietf