On Fri, May 2, 2014 at 8:00 PM, patricia <[email protected]> wrote:
> During the installation procedure library IGRAPH using cygwin, when > running the command <"make check"> at the end of several test execution > finished with status <failed>. I wonder if this may cause a problem (error) > future or if that act is considered normal. > That's probably OK if make install was OK. make check used to fail on cygwin. Gabor > > If not, what should I run correction procedures? > > Thank you > > _______________________________________________ > igraph-help mailing list > [email protected] > https://lists.nongnu.org/mailman/listinfo/igraph-help > >
_______________________________________________ igraph-help mailing list [email protected] https://lists.nongnu.org/mailman/listinfo/igraph-help
