We used to adjust the contrast of multichannel Z series and then make a 3D
projection
e.g. run("3D Project...", "projection=[Brightest Point] axis=X-Axis slice=1
initial=0 total=360 rotation=10 lower=1 upper=255 opacity=0 surface=50
interior=25 interpolate");
and the contrast we set was applied to the projection.
Recently when we've been doing this, the contrast has been reset to the full
range in the result instead of the contrast we set before running 3D projection.
Is there a setting that has changed and we could change back?
Thank you.
Michael Cammer, Sr Research Scientist, DART Microscopy Laboratory
NYU Langone Health, 540 First Avenue, New York, NY 10016
Office: RB (formerly Skirball) 4-102 -- call if door is locked (phone near
elevators)
Office: 646-501-0567 Cell (voice only, not text): 914-309-3270
[email protected]<mailto:[email protected]>
http://nyulmc.org/micros http://microscopynotes.com/
DO NOT SEND A REACTION. IF YOU WANT ME TO SEE A REPLY, SEND A NORMAL EMAIL
REPLY.
Similarly, I do not monitor Webex messages, texts, Slack, or other channels.
Send all written requests and replies to this email address.
Scheduling the time you want is far more reliable by phone call. Why not
provide your phone number?
______________________________________
This email message, including any attachments, is for the sole use of the
intended recipient(s) and may contain information that is proprietary,
confidential, and exempt from disclosure under applicable law. Any unauthorized
review, use, disclosure, or distribution is prohibited. If you have received
this email in error please notify the sender by return email and delete the
original message. Please note, the recipient should check this email and any
attachments for the presence of viruses. The organization accepts no liability
for any damage caused by any virus transmitted by this email.
--
ImageJ mailing list: http://imagej.nih.gov/ij/list.html