I am running Indiana preview 2 and I would like to create a non-global
ip-exclusive zone to use interface iprb0.
I used the following commands to install the zone:
[EMAIL PROTECTED]:/# zonecfg -z webserver
webserver: No such zone configured
Use 'create' to begin configuring a new zone.
zonecfg:webserver> create -t SUNWipkg
zonecfg:webserver> set zonepath=/zones/webserver
zonecfg:webserver> verify
zonecfg:webserver> set autoboot=true
zonecfg:webserver> set ip-type=exclusive
zonecfg:webserver> add net
zonecfg:webserver:net> set physical=iprb0
zonecfg:webserver:net> end
zonecfg:webserver> add device
zonecfg:webserver:device> set match=/dev/iprb0
zonecfg:webserver:device> end
zonecfg:webserver> commit
zonecfg:webserver> exit
When I try to install the zone I get the following message:
[EMAIL PROTECTED]:/zones# zoneadm -z webserver install
WARNING: skipping network interface 'iprb0' which is used in the global zone.
[EMAIL PROTECTED]:/zones# zoneadm -z webserver boot
WARNING: skipping network interface 'iprb0' which is used in the global zone.
zoneadm: zone 'webserver': WARNING: skipping network interface 'iprb0' which is
used in the global zone.: Not owner
[EMAIL PROTECTED]:/zones# dladm set-linkprop -t -p zone=webserver iprb0
dladm: warning: cannot set link property 'zone' on 'iprb0': device busy
[EMAIL PROTECTED]:/zones# ifconfig -a
lo0: flags=2001000849<UP,LOOPBACK,RUNNING,MULTICAST,IPv4,VIRTUAL> mtu 8232
index 1
inet 127.0.0.1 netmask ff000000
bnx0: flags=201004843<UP,BROADCAST,RUNNING,MULTICAST,DHCP,IPv4,CoS> mtu 1500
index 7
inet 10.44.119.177 netmask ffffff00 broadcast 10.44.119.255
ether 0:1e:4f:23:eb:df
bnx1: flags=201000802<BROADCAST,MULTICAST,IPv4,CoS> mtu 1500 index 5
inet 0.0.0.0 netmask 0
ether 0:1e:4f:23:eb:e1
iprb0: flags=201000842<BROADCAST,RUNNING,MULTICAST,IPv4,CoS> mtu 1500 index 6
inet 0.0.0.0 netmask ff000000 broadcast 0.255.255.255
ether 0:90:27:8e:95:5b
lo0: flags=2002000849<UP,LOOPBACK,RUNNING,MULTICAST,IPv6,VIRTUAL> mtu 8252
index 1
inet6 ::1/128
I don't have an entry for iprb0 in my /etc/nwam/llp
Here is output of dladm-showlink:
bnx1 type: non-vlan mtu: 1500 device: bnx1
iprb0 type: non-vlan mtu: 1500 device: iprb0
bnx0 type: non-vlan mtu: 1500 device: bnx0
Thanks in advance.
--
This message posted from opensolaris.org
_______________________________________________
indiana-discuss mailing list
[email protected]
http://mail.opensolaris.org/mailman/listinfo/indiana-discuss
