Op 10-10-17 om 18:14 schreef Ville Syrjälä:
> On Tue, Oct 10, 2017 at 06:04:28PM +0200, Maarten Lankhorst wrote:
>> If all outputs are disabled before this test is run, then the test
>> will fail because actual_brightness stays at 0 instead of the value
>> of the desired brightness. Fix this by enabling all outputs at the
>> start of this test.
>>
>> Sample failure:
>> IGT-Version: 1.20-g01c550a27986 (x86_64) (Linux: 4.14.0-rc3-fbconhax+ x86_64)
>> (pm_backlight:1203) CRITICAL: Test assertion failure function
>> test_and_verify, file pm_backlight.c:111:
>> (pm_backlight:1203) CRITICAL: Failed assertion: ({ typeof(0) _a = (0);
>> typeof(val - tolerance) _b = (val - tolerance); _a > _b ? _a : _b; }) <=
>> result
>> (pm_backlight:1203) CRITICAL: error: 91200 > 0
>>
>> Signed-off-by: Maarten Lankhorst <maarten.lankho...@linux.intel.com>
>> ---
>> tests/pm_backlight.c | 27 +++++++++++++++++++++++++++
>> 1 file changed, 27 insertions(+)
>>
>> diff --git a/tests/pm_backlight.c b/tests/pm_backlight.c
>> index 8258d4e4c124..b365c7f6dc60 100644
>> --- a/tests/pm_backlight.c
>> +++ b/tests/pm_backlight.c
>> @@ -155,13 +155,37 @@ igt_main
>> {
>> struct context context = {0};
>> int old;
>> + igt_display_t display;
>>
>> igt_skip_on_simulation();
>>
>> igt_fixture {
>> + enum pipe pipe;
>> +
>> /* Get the max value and skip the whole test if sysfs interface
>> not available */
>> igt_skip_on(backlight_read(&old, "brightness"));
>> igt_assert(backlight_read(&context.max, "max_brightness") > -1);
>> +
>> + /*
>> + * Backlight tests requires the output to be enabled,
>> + * try to enable all.
>> + */
>> + kmstest_set_vt_graphics_mode();
>> + igt_display_init(&display, drm_open_driver(DRIVER_INTEL));
>> +
>> + for_each_pipe(&display, pipe) {
>> + igt_output_t *output;
>> +
>> + for_each_valid_output_on_pipe(&display, pipe, output) {
>> + if (output->pending_pipe != PIPE_NONE)
>> + continue;
>> +
>> + igt_output_set_pipe(output, pipe);
>> + break;
>> + }
>> + }
> Since the test depends on intel_backlight I think we could even look up
> the correct backlight based on the connector. Would actually guarantee
> that we manage to light up the correct connector instead of wasting our
> precious pipes lighting up stuff we don't need.
Through readlink /sys/class/backlight/intel_backlight/device you mean? Should
be doable, but feels hacky..
_______________________________________________
Intel-gfx mailing list
Intel-gfx@lists.freedesktop.org
https://lists.freedesktop.org/mailman/listinfo/intel-gfx
