Chris Wilson <ch...@chris-wilson.co.uk> writes: > Quoting Francisco Jerez (2020-03-10 21:41:55) >> diff --git a/drivers/gpu/drm/i915/gt/intel_lrc.c >> b/drivers/gpu/drm/i915/gt/intel_lrc.c >> index b9b3f78f1324..a5d7a80b826d 100644 >> --- a/drivers/gpu/drm/i915/gt/intel_lrc.c >> +++ b/drivers/gpu/drm/i915/gt/intel_lrc.c >> @@ -1577,6 +1577,11 @@ static void execlists_submit_ports(struct >> intel_engine_cs *engine) >> /* we need to manually load the submit queue */ >> if (execlists->ctrl_reg) >> writel(EL_CTRL_LOAD, execlists->ctrl_reg); >> + >> + if (execlists_num_ports(execlists) > 1 && > pending[1] is always defined, the minimum submission is one slot, with > pending[1] as the sentinel NULL. > >> + execlists->pending[1] && >> + !atomic_xchg(&execlists->overload, 1)) >> + intel_gt_pm_active_begin(&engine->i915->gt); > > engine->gt >
Applied your suggestions above locally, will probably wait to have a few more changes batched up before sending a v2. >> } >> >> static bool ctx_single_port_submission(const struct intel_context *ce) >> @@ -2213,6 +2218,12 @@ cancel_port_requests(struct intel_engine_execlists * >> const execlists) >> clear_ports(execlists->inflight, ARRAY_SIZE(execlists->inflight)); >> >> WRITE_ONCE(execlists->active, execlists->inflight); >> + >> + if (atomic_xchg(&execlists->overload, 0)) { >> + struct intel_engine_cs *engine = >> + container_of(execlists, typeof(*engine), execlists); >> + intel_gt_pm_active_end(&engine->i915->gt); >> + } >> } >> >> static inline void >> @@ -2386,6 +2397,9 @@ static void process_csb(struct intel_engine_cs *engine) >> /* port0 completed, advanced to port1 */ >> trace_ports(execlists, "completed", >> execlists->active); >> >> + if (atomic_xchg(&execlists->overload, 0)) >> + intel_gt_pm_active_end(&engine->i915->gt); > > So this looses track if we preempt a dual-ELSP submission with a > single-ELSP submission (and never go back to dual). > Yes, good point. You're right that if a dual-ELSP submission gets preempted by a single-ELSP submission "overload" will remain signaled until the first completion interrupt arrives (e.g. from the preempting submission). > If you move this to the end of the loop and check > > if (!execlists->active[1] && atomic_xchg(&execlists->overload, 0)) > intel_gt_pm_active_end(engine->gt); > > so that it covers both preemption/promotion and completion. > That sounds reasonable. > However, that will fluctuate quite rapidly. (And runs the risk of > exceeding the sentinel.) > > An alternative approach would be to couple along > schedule_in/schedule_out > > atomic_set(overload, -1); > > __execlists_schedule_in: > if (!atomic_fetch_inc(overload) > intel_gt_pm_active_begin(engine->gt); > __execlists_schedule_out: > if (!atomic_dec_return(overload) > intel_gt_pm_active_end(engine->gt); > > which would mean we are overloaded as soon as we try to submit an > overlapping ELSP. > That sounds good to me too, and AFAICT would have roughly the same behavior as this metric except for the preemption corner case you mention above. I'll try this and verify that I get approximately the same performance numbers. > > The metric feels very multiple client (game + display server, or > saturated transcode) centric. In the endless kernel world, we expect > 100% engine utilisation from a single context, and never a dual-ELSP > submission. They are also likely to want to avoid being throttled to > converse TDP for the CPU. > Yes, this metric is fairly conservative, it won't trigger in all cases which would potentially benefit from the energy efficiency optimization, only where we can be reasonably certain that CPU latency is not critical in order to keep the GPU busy (e.g. because the CS has an additional ELSP port pending execution that will immediately kick in as soon as the current one completes). My original approach was to call intel_gt_pm_active_begin() directly as soon as the first ELSP is submitted to the GPU, which was somewhat more effective at improving the energy efficiency of the system than waiting for the second port to be in use, but it involved a slight execlists submission latency cost that led to some regressions. It would certainly cover the single-context case you have in mind though. I'll get some updated numbers with my previous approach so we can decide which one provides a better trade-off. > Should we also reduce the overload for the number of clients who are > waiting for interrupts from the GPU, so that their wakeup latency is not > impacted? A number of clients waiting doesn't necessarily indicate that wake-up latency is a concern. It frequently indicates the opposite: That the GPU has a bottleneck which will only be exacerbated by attempting to reduce the ramp-up latency of the CPU. IOW, I think we should only care about reducing the CPU wake-up latency in cases where the client is unable to keep the GPU fully utilized with the latency target which allows the GPU to run at maximum throughput -- If the client is unable to it will already cause the GPU utilization to drop, so the PM QoS request will be removed whether it is waiting or not. > -Chris Thanks!
signature.asc
Description: PGP signature
_______________________________________________ Intel-gfx mailing list Intel-gfx@lists.freedesktop.org https://lists.freedesktop.org/mailman/listinfo/intel-gfx