On Tue, 2016-05-17 at 21:21 +0300, Ville Syrjälä wrote:
> On Tue, May 17, 2016 at 09:09:15PM +0300, Imre Deak wrote:
> > On Fri, 2016-05-13 at 23:41 +0300, ville.syrj...@linux.intel.com
> > wrote:
> > > From: Ville Syrjälä <ville.syrj...@linux.intel.com>
> > >
> > > commit 4e5ca60fd35a ("drm/i915: Use ilk_max_pixel_rate() for BXT
> > > cdclk calculation")
> > > tried to change BXT to use ilk_max_pixel_rate() to compute the
> > > pipe pixel rate. I failed to notice that there was another place
> > > in the state readout code that needs the same treatment. So let's
> > > change that one too.
> > >
> > > Should probably just change things to always compuyte the pipe
> > > pixel
> > > rates, instead of just doing on platforms that can change cdclk
> > > dynamically. But for now let's just move BXT fully over to the
> > > side that uses ilk_pipe_pixel_rate().
> > >
> > > Cc: Jani Nikula <jani.nik...@intel.com>
> > > Fixes: 4e5ca60fd35a ("drm/i915: Use ilk_max_pixel_rate() for BXT
> > > cdclk calculation")
> > > Signed-off-by: Ville Syrjälä <ville.syrj...@linux.intel.com>
> >
> > Reviewed-by: Imre Deak <imre.d...@intel.com>
> >
> > Btw, there is also skl_pipe_pixel_rate() that needs the same
> > change.
>
> Oh dear. Just how many of these things do we need? I'll send a patch
> to just
> nuke the skl version.
Ohm, I guess I was wrong. For WM we only need to adjust for pipe
scaling not plane scaling if I read the spec correctly. But removing
duplicate helpers if possible doesn't hurt in any case.
> >
> > > ---
> > > drivers/gpu/drm/i915/intel_display.c | 14 ++++++--------
> > > 1 file changed, 6 insertions(+), 8 deletions(-)
> > >
> > > diff --git a/drivers/gpu/drm/i915/intel_display.c
> > > b/drivers/gpu/drm/i915/intel_display.c
> > > index c5f0a6f30879..cc9a8b42fbc6 100644
> > > --- a/drivers/gpu/drm/i915/intel_display.c
> > > +++ b/drivers/gpu/drm/i915/intel_display.c
> > > @@ -15748,18 +15748,16 @@ static void
> > > intel_modeset_readout_hw_state(struct drm_device *dev)
> > > if (crtc_state->base.active) {
> > > dev_priv->active_crtcs |= 1 << crtc-
> > > >pipe;
> > >
> > > - if (IS_BROADWELL(dev_priv)) {
> > > + if (IS_BROXTON(dev_priv) ||
> > > IS_BROADWELL(dev_priv))
> > > pixclk =
> > > ilk_pipe_pixel_rate(crtc_state);
> > > -
> > > - /* pixel rate mustn't exceed 95%
> > > of cdclk with IPS on BDW */
> > > - if (crtc_state->ips_enabled)
> > > - pixclk =
> > > DIV_ROUND_UP(pixclk * 100, 95);
> > > - } else if (IS_VALLEYVIEW(dev_priv) ||
> > > - IS_CHERRYVIEW(dev_priv) ||
> > > - IS_BROXTON(dev_priv))
> > > + else if (IS_VALLEYVIEW(dev_priv) ||
> > > IS_CHERRYVIEW(dev_priv))
> > > pixclk = crtc_state-
> > > >base.adjusted_mode.crtc_clock;
> > > else
> > > WARN_ON(dev_priv-
> > > >display.modeset_calc_cdclk);
> > > +
> > > + /* pixel rate mustn't exceed 95% of
> > > cdclk with IPS on BDW */
> > > + if (IS_BROADWELL(dev_priv) &&
> > > crtc_state->ips_enabled)
> > > + pixclk = DIV_ROUND_UP(pixclk *
> > > 100, 95);
> > > }
> > >
> > > dev_priv->min_pixclk[crtc->pipe] = pixclk;
>
_______________________________________________
Intel-gfx mailing list
Intel-gfx@lists.freedesktop.org
https://lists.freedesktop.org/mailman/listinfo/intel-gfx
