On Sat, Nov 28, 2015 at 10:19:14AM +0800, chenfeng wrote:
> On 2015/11/27 20:02, Joerg Roedel wrote:
> > You need to create an iommu-group per smmu in your system and put all
> > devices translated by this smmu in that group. And then you must change
> > your code to allow attaching/detaching this iommu-group to different
> > domains.
> >
> I read the code,I am confused about these concepts.
> In my opinion,
> IOMMU-Domain: The masters in one domain share the same iova space. Is that
> right?
Yes, an iommu-domain is an abstraction of a single page-table and
describes one iova address space. The SMMU in your hardware supports
only on page-table, so all devices behind it share a single iova address
space, und must be in the same domain.
But the way you implemented it there could be only one domain per SMMU.
With the IOMMU-API we must support to change the domain of an SMMU.
Think of one domain for DMA-API usage and another for VFIO, for example.
> IOMMU-GROUP: As you mentioned up,all devices translated by this smmu
> should be into one group. I can do this. But if there is only on
> domain in the system, how can I attaching/detaching the group to
> different domains.
IOMMU-groups describe the isolation capabilities of the IOMMU between
devices. If devices are in a different IOMMU-group, this means that
the hardware can isolate them from each other.
Attaching the devices in a group to a new domain means in your case,
that you set a different page-table for them. Since you can only do that
for all devices behind a SMMU, these devices must be in on IOMMU-group.
Joerg
_______________________________________________
iommu mailing list
iommu@lists.linux-foundation.org
https://lists.linuxfoundation.org/mailman/listinfo/iommu
