I'm looking for a guideline on how Access Control Services (ACS) need to be implemented in HW for cases where peer to peer is and isn't supported.
I see conflicting information in the code. iommu.c calls pci_acs_enabled() from pci_device_group() to determine if ACS path is enabled for the following flags. This paragraph lays out the requirements. /* * To consider a PCI device isolated, we require ACS to support Source * Validation, Request Redirection, Completer Redirection, and Upstream * Forwarding. This effectively means that devices cannot spoof their * requester ID, requests and completions cannot be redirected, and all * transactions are forwarded upstream, even as it passes through a * bridge where the target device is downstream. */ #define REQ_ACS_FLAGS (PCI_ACS_SV | PCI_ACS_RR | PCI_ACS_CR | PCI_ACS_UF) I also see the following comment in pci_acs_flags_enabled() which gets called from pci_acs_enabled() /* * Except for egress control, capabilities are either required * or only required if controllable. Features missing from the * capability field can therefore be assumed as hard-wired enabled. */ This comment in pci_acs_flags_enabled() is confusing. A capability that reads 0 usually means it is not enabled. This code is assuming enabled. Are we trying to say that we'll use the capability bits as a mask while verifying the requested ACS flags? For systems that don't support P2P, the code will check PCI_ACS_SV only. So, if I summarize this correctly; The requirement is to have an 1. ACS capability with PCI_ACS_SV if p2p is not supported 2. ACS capability with PCI_ACS_SV|PCI_ACS_RR | PCI_ACS_CR | PCI_ACS_UF if p2p is supported. Did I get this right? -- Sinan Kaya Qualcomm Datacenter Technologies, Inc. as an affiliate of Qualcomm Technologies, Inc. Qualcomm Technologies, Inc. is a member of the Code Aurora Forum, a Linux Foundation Collaborative Project. _______________________________________________ iommu mailing list iommu@lists.linux-foundation.org https://lists.linuxfoundation.org/mailman/listinfo/iommu