On Thu, May 20, 2021 at 05:03:06PM -0500, Rob Herring wrote: > On Fri, Apr 23, 2021 at 06:32:30PM +0200, Thierry Reding wrote: > > From: Thierry Reding <tred...@nvidia.com> > > > > Reserved memory region phandle references can be accompanied by a > > specifier that provides additional information about how that specific > > reference should be treated. > > > > One use-case is to mark a memory region as needing an identity mapping > > in the system's IOMMU for the device that references the region. This is > > needed for example when the bootloader has set up hardware (such as a > > display controller) to actively access a memory region (e.g. a boot > > splash screen framebuffer) during boot. The operating system can use the > > identity mapping flag from the specifier to make sure an IOMMU identity > > mapping is set up for the framebuffer before IOMMU translations are > > enabled for the display controller. > > > > Signed-off-by: Thierry Reding <tred...@nvidia.com> > > --- > > .../reserved-memory/reserved-memory.txt | 21 +++++++++++++++++++ > > include/dt-bindings/reserved-memory.h | 8 +++++++ > > 2 files changed, 29 insertions(+) > > create mode 100644 include/dt-bindings/reserved-memory.h > > Sorry for being slow on this. I have 2 concerns. > > First, this creates an ABI issue. A DT with cells in 'memory-region' > will not be understood by an existing OS. I'm less concerned about this > if we address that with a stable fix. (Though I'm pretty sure we've > naively added #?-cells in the past ignoring this issue.)
A while ago I had proposed adding memory-region*s* as an alternative name for memory-region to make the naming more consistent with other types of properties (think clocks, resets, gpios, ...). If we added that, we could easily differentiate between the "legacy" cases where no #memory-region-cells was allowed and the new cases where it was. > Second, it could be the bootloader setting up the reserved region. If a > node already has 'memory-region', then adding more regions is more > complicated compared to adding new properties. And defining what each > memory-region entry is or how many in schemas is impossible. It's true that updating the property gets a bit complicated, but it's not exactly rocket science. We really just need to splice the array. I have a working implemention for this in U-Boot. For what it's worth, we could run into the same issue with any new property that we add. Even if we renamed this to iommu-memory-region, it's still possible that a bootloader may have to update this property if it already exists (it could be hard-coded in DT, or it could have been added by some earlier bootloader or firmware). > Both could be addressed with a new property. Perhaps something like > 'iommu-memory-region = <&phandle>;'. I think the 'iommu' prefix is > appropriate given this is entirely because of the IOMMU being in the > mix. I might feel differently if we had other uses for cells, but I > don't really see it in this case. I'm afraid that down the road we'll end up with other cases and then we might proliferate a number of *-memory-region properties with varying prefixes. I am aware of one other case where we might need something like this: on some Tegra SoCs we have audio processors that will access memory buffers using a DMA engine. These processors are booted from early firmware using firmware from system memory. In order to avoid trashing the firmware, we need to reserve memory. We can do this using reserved memory nodes. However, the audio DMA engine also uses the SMMU, so we need to make sure that the firmware memory is marked as reserved within the SMMU. This is similar to the identity mapping case, but not exactly the same. Instead of creating a 1:1 mapping, we just want that IOVA region to be reserved (i.e. IOMMU_RESV_RESERVED instead of IOMMU_RESV_DIRECT{,_RELAXABLE}). That would also fall into the IOMMU domain, but we can't reuse the iommu-memory-region property for that because then we don't have enough information to decide which type of reservation we need. We could obviously make iommu-memory-region take a specifier, but we could just as well use memory-regions in that case since we have something more generic anyway. With the #memory-region-cells proposal, we can easily extend the cell in the specifier with an additional MEMORY_REGION_IOMMU_RESERVE flag to take that other use case into account. If we than also change to the new memory-regions property name, we avoid the ABI issue (and we gain a bit of consistency while at it). Thierry
signature.asc
Description: PGP signature
_______________________________________________ iommu mailing list iommu@lists.linux-foundation.org https://lists.linuxfoundation.org/mailman/listinfo/iommu