Dear Frank and Phil:

I very much appreciate your comments.  Thank you.  Though I apparently
followed the correct installation file (INSTALL.Sol2), since there is no
other idea on the table--I think I will follow Frank's advice.  That is, to
remove the package and attempt to reinstall it per Frank's below advise
regarding the pre-built versions.  Does this seem reasonable?  I will tell
you how it turns out.  Thank you very, VERY, much for your time.

Eric

----- Original Message -----
From: "Frank Lewandowski" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Saturday, May 04, 2002 11:22 PM
Subject: RE: Solaris 8 with no IPnat


> Hi Eric,
>
> The installation you chose is for Solaris 2.x versions, so all prior to
> version 7, as you can see from your uname output, you run Solaris 5.8,
> which is 8 in fact, most installation/build files are called "Solaris",
> not "sol2", this indicates older builds of Solaris.
>
> For Solaris 8, you can get pre-built versions on www.sunfreeware.com,
> choose "Solaris 8" on top right frame, or you go to
> http://anders.fix.no/solaris/pkg/sol8/sparc32-64/ , where you find more
> pre-builds for Solaris 8, including the current IPFilter version in
> 32/64 bit, I used this one, and it runs perfect for me, including NAT.
>
> You may read through your "INSTALL.Sol2" and "INSTALL.solaris" files to
> find more details about the differences.
>
> Cheers, Frank
>
>
>
> -----Original Message-----
> From: [EMAIL PROTECTED]
> [mailto:[EMAIL PROTECTED]] On Behalf Of Eric A. Sauer
> Sent: Saturday, May 04, 2002 11:38 PM
> To: [EMAIL PROTECTED]
> Subject: Solaris 8 with no IPnat
>
>
> [Hello:
>
> I am running, as indicated below, Solaris 8 on an Ultra 5 machine and I
> am attempting to use IP Filter 3.4.25.  I followed the directions for
> installation per the file "INSTALL.Sol2" and the installation appeared
> to go smoothly (ipf.conf appears to be working); however, I did not get
> /dev/ipnat and as one can imagine am unable to run ipnat.  Per the FAQ
> directions, I am including the designated commands and their output.
>
> Sun Microsystems Inc.   SunOS 5.8       Generic February 2000
> # uname -a
> SunOS unknown 5.8 Generic_108528-13 sun4u sparc SUNW,Ultra-5_10
> # isainfo -vk
> 32-bit sparc kernel modules
> # ifconfig -a
> lo0: flags=1000849<UP,LOOPBACK,RUNNING,MULTICAST,IPv4> mtu 8232 index 1
>         inet 127.0.0.1 netmask ff000000
> hme0: flags=1000843<UP,BROADCAST,RUNNING,MULTICAST,IPv4> mtu 1500 index
> 2
>         inet 12.253.225.130 netmask fffffc00 broadcast 12.253.227.255
>         ether 8:0:20:b9:38:5d
> # netstat -rn
>
> Routing Table: IPv4
>   Destination           Gateway           Flags  Ref   Use   Interface
> -------------------- -------------------- ----- ----- ------ ---------
> 12.253.224.0         12.253.225.130        U        1      3  hme0
> default              12.253.224.1          UG       1     23
> 127.0.0.1            127.0.0.1             UH      22   6454  lo0
> # netstat -i
> Name  Mtu  Net/Dest      Address        Ipkts  Ierrs Opkts  Oerrs Collis
> Queue
> lo0   8232 loopback      localhost      6482   0     6482   0     0
> 0
> hme0  1500 dhcp-87-4618  dhcp-87-4618   4803   0     796    0     20
> 0
>
> # netstat -s -P ip
>
>
> IPv4    ipForwarding        =     2     ipDefaultTTL        =   255
>         ipInReceives        =   828     ipInHdrErrors       =     0
>         ipInAddrErrors      =     0     ipInCksumErrs       =     0
>         ipForwDatagrams     =     0     ipForwProhibits     =     0
>         ipInUnknownProtos   =     0     ipInDiscards        =     0
>         ipInDelivers        =  7360     ipOutRequests       =   791
>         ipOutDiscards       =     0     ipOutNoRoutes       =     0
>         ipReasmTimeout      =    60     ipReasmReqds        =     0
>         ipReasmOKs          =     0     ipReasmFails        =     0
>         ipReasmDuplicates   =     0     ipReasmPartDups     =     0
>         ipFragOKs           =     0     ipFragFails         =     0
>         ipFragCreates       =     0     ipRoutingDiscards   =     0
>         tcpInErrs           =     0     udpNoPorts          =     0
>         udpInCksumErrs      =     0     udpInOverflows      =     0
>         rawipInOverflows    =     0     ipsecInSucceeded    =     0
>         ipsecInFailed       =     0     ipInIPv6            =     0
>         ipOutIPv6           =     0     ipOutSwitchIPv6     =     1
> # ipf -V
> ipf: IP Filter: v3.4.25 (432)
> Kernel: IP Filter: v3.4.25
> Running: yes
> Log Flags: 0 = none set
> Default: pass all, Logging: available
> Active list: 1
> # ipfstat
> dropped packets:        in 0    out 0
> non-data packets:       in 5    out 5
> no-data packets:        in 0    out 0
> non-ip packets:         in 0    out 0
>    bad packets:         in 0    out 0
> copied messages:        in 0    out 126
>  IPv6 packets:          in 0 out 0
>  input packets:         blocked 66 passed 828 nomatch 0 counted 0 short
> 0
> output packets:         blocked 0 passed 791 nomatch 0 counted 0 short 0
>
>  input packets logged:  blocked 4 passed 0
> output packets logged:  blocked 0 passed 0
>  packets logged:        input 0 output 0
>  log failures:          input 0 output 0
> fragment state(in):     kept 0  lost 0
> fragment state(out):    kept 0  lost 0
> packet state(in):       kept 0  lost 0
> packet state(out):      kept 133        lost 0
> ICMP replies:   0       TCP RSTs sent:  0
> Invalid source(in):     0
> Result cache hits(in):  60      (out):  0
> IN Pullups succeeded:   0       failed: 0
> OUT Pullups succeeded:  0       failed: 0
> Fastroute successes:    0       failures:       0
> TCP cksum fails(in):    0       (out):  0
> Packet log flags set: (0)
>         none
> # ipfstat -io
> pass out quick on hme0 proto tcp from 12.253.225.130/32 to any keep
> state
> pass out quick on hme0 proto udp from 12.253.225.130/32 to any keep
> state
> pass out quick on hme0 proto icmp from 12.253.225.130/32 to any keep
> state
> block in quick on hme0 from any to 255.255.255.255/32
> pass in quick on hme0 from 12.253.227.119/32 to any
> block return-rst in log proto tcp from any to 12.253.225.130/32
> block return-icmp-as-dest(port-unr) in log on hme0 proto udp from any to
> 12.253.225.130/32
> block in log quick on hme0 from any to any
> # ipnat -slv
> /dev/ipnat: open: No such file or directory
>
> Please advise.  Thank you.
>
> Eric Sauer]
>
>

Reply via email to