Hi, all This is not talking about a new idea. The " Parameterized IP-Specific configuration" comes from the 6renum WG item, see http://tools.ietf.org/html/draft-ietf-6renum-gap-analysis-04#page-11
The draft is under 6renum WGLC, according to the comment in the Atlanta meeting, we need your review/comment of whether the "Parameterized IP-specific configuration" is a proper expression. And if you still have other comments of the document, that would be also appreciated very much. Thanks a lot. B.R. Bing ****For your convenient, abstract the original texts here**** (In draft-ietf-6renum-gap-analysis-04#page-11) 6.3. Parameterized IP-specific Configuration Besides the DNS records and the in-host server address entries, there are also many places in which the IP addresses are configured, for example, filters such as ACL and routing policies, etc. There are even more sophisticated cases where the IP addresses are used for deriving values, for example, using the unique portion of the loopback address to generate an ISIS net ID. Ideally, a layer of abstraction for IP-specific configuration within various devices (routers, switches, hosts, servers, etc.) is needed. However, this cannot be achieved in one step. One possible improvement is to make the IP-specific configuration parameterized. Two aspects of parameterized configuration could be considered to achieve this. ... Here's an example (not in the draft, just for your easy understanding the above texts.) First, we define the addresses for a given interface interface gigabitethernet1/1 ipv4 address 192.0.2.10/24 ipv6 address 2001:db8::10/64 Note that these addresses could also be automatically configured using DHCP or SLAAC, perhaps then the example would be: Interface gigabitethernet1/1 ipv4 address dynamic dhcp ipv6 address dynamic dhcpv6 then elsewhere in the configuration: access-list example1 permit ipv4 any [gigabitethernet1/1] mask /24 #this permits any ip address that matches the prefix assigned to the interface in brackets [], in the range defined by the subnet mask at the end of the command permit ipv6 any [gigabitethernet1/1] mask /48 #this is the ipv6 equivalent, but permits any address in the entire /48 Similar examples could be possible for a BGP session, snmp source address, etc. Anywhere else you would hard-code an IP address could use a parameter to invoke an address inherited from an interface. -------------------------------------------------------------------- IETF IPv6 working group mailing list ipv6@ietf.org Administrative Requests: https://www.ietf.org/mailman/listinfo/ipv6 --------------------------------------------------------------------
