--- Patrick Martin <[EMAIL PROTECTED]> wrote:
>
>
> I would be surprised if the KOHI radials are gone.
Wouldn't surprise me a bit.
> They have been at that site for about 20 years.
It could have eroded, and who knows what the problem
is. Now, if there is a ground system problem and it
detunes the whole thing, a tube type transmitter
generally will work. A solid state transmitter will
reduce power or if there is major mismatch, simply not
work.
> It must be something else that is causing the signal
change.
NEVER make assumptions that it must or must not be
something.
WCAM 1590 a good while back kicked off the air one
morning at full power up. The Harris SX-1 would work
up to 100 watts and any other power it would trip off.
Even with a RF Bridge nothing seemed warm, none of
the caps in the ATU checked bad. Impedence was
slightly changed. One of the caps in the ATU WAS bad,
and it didn't show up and screw up until power over
100 watts was applied. After that WCAM sounded better
than it had in some time and the SX-1 didn't wheeze to
make power.
Powell
_______________________________________________
IRCA mailing list
IRCA@hard-core-dx.com
http://montreal.kotalampi.com/mailman/listinfo/irca
Opinions expressed in messages on this mailing list are those of the original
contributors and do not necessarily reflect the opinion of the IRCA, its
editors, publishing staff, or officers
For more information: http://www.ircaonline.org
To Post a message: irca@hard-core-dx.com
