Got the new Perseus SDR hooked up and running last night using SDRV4.1
downloaded from the Perseus web site. No problems at all with the
initial installation on Windows 7 Pro. Had it working within moments.
One issue I did notice was that when I used the Perseus with the
SDR-Console software, the AF output volume was much lower compared to
the native Perseus software. No idea why this would be, and couldn't
find a place to adjust the level inside the SDR-Console software. Can
someone offer assistance?
RF levels appeared to be the same for both software.
So far, I love the Perseus! One other question--how much bandwidth can
the Perseus record in I/O mode? I've seen some sites that say it's
limited to 800 KHz, others say 1600 KHz, and others 2 MHz. My
understanding is that it would cover the entire AM band, which would be
1710 KHz (1.7 MHz)
--
73,
Les Rayburn, N1LF
Maylene, AL
EM63
Member NRC, IRCA, & Medium Wave DX Circle
Former CPC Chairman for NRC/IRCA
SDR-IQ,Funcube Pro, Wellbrooke ALA-1530+ loop, LF Engineering Active Whips,
Quantum Phaser, Kiwa Loop, Palstar MW Pre-Selector
_______________________________________________
IRCA mailing list
IRCA@hard-core-dx.com
http://montreal.kotalampi.com/mailman/listinfo/irca
Opinions expressed in messages on this mailing list are those of the original
contributors and do not necessarily reflect the opinion of the IRCA, its
editors, publishing staff, or officers
For more information: http://www.ircaonline.org
To Post a message: irca@hard-core-dx.com