I'm trying to get a M10 to work in transparent mode. I am starting from scratch with a complete reinstall, updating the firmware to v3.10 I got it working once but could not get back into the management console after I did. I think I used the wrong value for management IP address. I set it to an IP in the subnet I'm trying deploy it on but it didn't work. I have found the documentation to be very vague, this appliance was dropped on my desk over a year ago to try and figure out and I lost patience with it but have been told to give it another shot for use at our other location.
Any help is much appreciated Michael _______________________________________________ ISSForum mailing list [email protected] TO UNSUBSCRIBE OR CHANGE YOUR SUBSCRIPTION, go to https://atla-mm1.iss.net/mailman/listinfo/issforum To contact the ISSForum Moderator, send email to [EMAIL PROTECTED] The ISSForum mailing list is hosted and managed by Internet Security Systems, 6303 Barfield Road, Atlanta, Georgia, USA 30328.
