TO UNSUBSCRIBE: email "unsubscribe issforum" in the body of your message to
[EMAIL PROTECTED] Contact [EMAIL PROTECTED] for help with any problems!
----------------------------------------------------------------------------
1. These can be turned on or off by doing the following
Highlight the engine
>From the engine window menu select "Properties"
Click on the Alerts tab (note - if you are not master console for this
engine these options will be greyed out and you connot change them).
Uncheck the Detector_xxxx messages that you do not wish to receive.
2. To send an SNMP message upon daemon channel errors, etc. do NOT uncheck
the appropriate detector_xxxx box, AND check the SNMP check box and
configure from there.
Also, the console and engine *do* try to reconnect with each other if the
channel has been dropped for one reason or another, though I am not sure
what the values for "X and "Y" are.
Hope this helps a little,
Alex F
[EMAIL PROTECTED]
-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED]]
Sent: Thursday, January 06, 2000 7:54 AM
To: [EMAIL PROTECTED]; [EMAIL PROTECTED]
Cc: '[EMAIL PROTECTED]'; '[EMAIL PROTECTED]'
Subject: Re: RealSecure
TO UNSUBSCRIBE: email "unsubscribe issforum" in the body of your message to
[EMAIL PROTECTED] Contact [EMAIL PROTECTED] for help with any
problems!
----------------------------------------------------------------------------
We have several questions regarding RS 3.2 on issues that have popped up
recently and ongoing concerns.
1. We have turned on the email feature but notice that Detector
information
events send emails even though we can not see where this option is turned
on.
Is there any way we can control the types of alert messages (especially snmp
and
smtp) for information events of this nature? There is nothing in the help
file
or the screens for event messages that indicate snmp or smtp options for RS
management events.
2. Ongoing concern.
When the daemon channel connection drops, the console alert shows this
and
we currently have to perform a manual re-connect. Is there any way that the
console side can:
a. Send an snmp/smtp connection failure message.
b. attempt an automatic retry after x amount of down time for y
number of
times?
This would help us to not have to either come into the office or
perform
remote connections from home to the console to perform the reconnection.
Thanks,
Steve Sidebottom, CISA, CISSP