TO UNSUBSCRIBE: email "unsubscribe issforum" in the body of your message to
[EMAIL PROTECTED] Contact [EMAIL PROTECTED] for help with any problems!
----------------------------------------------------------------------------
And make sure you run the following command (mine is at the end of
/etc/init.d/realsecure)
/usr/sbin/ifconfig <your_monitoring_interface> plumb -arp
-----Original Message-----
From: ISS Technical Support [mailto:[EMAIL PROTECTED]]
Sent: Thursday, July 13, 2000 4:36 PM
To: 'Arie Elkins'; [EMAIL PROTECTED]
Subject: RE: RealSecure on Solaris
TO UNSUBSCRIBE: email "unsubscribe issforum" in the body of your message to
[EMAIL PROTECTED] Contact [EMAIL PROTECTED] for help with any
problems!
----------------------------------------------------------------------------
Hello Arie,
Be sure that you enable the console to monitor the outside NIC by going to
the Engine/Sensor Properties --> General tab. You should see two NIC in the
"Adapter of Monitor Network" area.
Tech Support Engineer
[EMAIL PROTECTED]
Toll free 1-888-447-4861 or Direct 678-443-6400
Hours of operation are Monday thru Friday 8:00am to 8:00pm
www.iss.net
Adaptive Network Security for the Enterprise.
-----Original Message-----
From: Arie Elkins [mailto:[EMAIL PROTECTED]]
Sent: Thursday, July 13, 2000 3:27 PM
To: [EMAIL PROTECTED]
Subject: RealSecure on Solaris
TO UNSUBSCRIBE: email "unsubscribe issforum" in the body of your message to
[EMAIL PROTECTED] Contact [EMAIL PROTECTED] for help with any
problems!
----------------------------------------------------------------------------
I'm having a problem setting up the RealSecure engine on Solaris. We've got
two nic cards in the machine, and we set up the first nic without an IP
address outside the firewall, but no matter what we do, it doesn't do
anything on that NIC card. It will only use the card we set inside the
firewall with an IP to pick up traffic. What could I be doing wrong?
