Hi, I have two different hauppauge cards, and i have problems with both of them.
I live in Sweden and uses Europe-pal. using .0.4.0 First of is a PVR-250. With this one i get a nice clear picture, but no sound (except for one channel. it has a label with PAL-B/G-I-D/K-SECAM 32059. Output from dmesg can be found below. The second card is a PVR-500 where i have sound, but quite bad reception (some channels are better than the others). Same thing on both tuners. This one has the following under the sticker on one of the tuner: FQ1216AME/R H-4 The output from dmesg can be found below. Any help would be appreciated allot! BR / Johan ivtv: ==================== START INIT IVTV ==================== ivtv: version 0.4.0 (tagged release) loading ivtv: Linux version: 2.6.10-5-686-smp SMP preempt 686 gcc-3.3 ivtv: In case of problems please include the debug info ivtv: between the START INIT IVTV and END INIT IVTV lines when ivtv: mailing the ivtv-devel mailinglist. ivtv0: Autodetected WinTV PVR 250 card (iTVC16 based) ACPI: PCI interrupt 0000:02:0a.0[A] -> GSI 22 (level, low) -> IRQ 22 tveeprom: ivtv version tveeprom: Hauppauge: model = 32059, rev = B143, serial# = 7263640 tveeprom: tuner = Temic 4046FM5 (idx = 43, type = 22) tveeprom: tuner fmt = PAL(B/G) PAL(I) SECAM(L/L') PAL(D/K) (eeprom = 0x74, v4l2 = 0x00400e17) tveeprom: audio processor = MSP4418 (type = 19) tveeprom: decoder processor = SAA7115 (type = 13) ivtv0: i2c attach to card #0 ok [client=tveeprom, addr=50] tuner (ivtv): chip found at addr 0xc2 i2c-bus ivtv i2c driver #0 ivtv0: i2c attach to card #0 ok [client=(tuner unset), addr=61] saa7115 1-0021: saa7115 found @ 0x42 (ivtv i2c driver #0) ivtv0: i2c attach to card #0 ok [client=saa7115, addr=21] msp34xx: ivtv version msp34xx: init: chip=MSP3418W-A2, has NICAM support, simple (D) mode, simpler (G) no-thread mode msp34xx: $Id$ compiled on: Oct 10 2005 17:44:36 ieee1394: Host added: ID:BUS[0-00:1023] GUID[00e01800008d7503] ivtv0: i2c attach to card #0 ok [client=MSP3418W-A2, addr=40] ivtv0: loading /lib/modules/ivtv-fw-enc.bin ivtv0: Encoder revision: 0x02040011 ivtv0: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB total) ivtv0: Allocate DMA encoder YUV stream: 161 x 12960 buffers (2048KB total) ivtv0: Allocate DMA encoder VBI stream: 80 x 26208 buffers (2048KB total) ivtv0: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers (2048KB total) tuner: type set to 22 (Temic PAL/SECAM multi (4046 FM5)) by ivtv i2c driver #0 ivtv0: Initialized WinTV PVR 250, card #0 ivtv: ====================== NEXT CARD ====================== ivtv1: Autodetected WinTV PVR 150 card (iTVC16 based) ACPI: PCI interrupt 0000:03:08.0[A] -> GSI 21 (level, low) -> IRQ 21 tveeprom: Second (radio) tuner idx 101 tveeprom: ivtv version tveeprom: Hauppauge: model = 23559, rev = D591, serial# = 2989473 tveeprom: tuner = Philips FQ1216AME MK4 (idx = 91, type = 56) tveeprom: tuner fmt = PAL(B/G) PAL(I) SECAM(L/L') PAL(D/K) (eeprom = 0x74, v4l2 = 0x00400e17) tveeprom: audio processor = CX25843 (type = 25) tveeprom: decoder processor = CX25843 (type = 1e) ivtv1: i2c attach to card #1 ok [client=tveeprom, addr=50] tuner (ivtv): chip found at addr 0xc0 i2c-bus ivtv i2c driver #1 TEA5767 detected. ivtv1: i2c attach to card #1 ok [client=(tuner unset), addr=60] tuner: type set to 62 (Philips TEA5767HN FM Radio) by autodetect type set to 62 (Philips TEA5767HN FM Radio) tuner (ivtv): chip found at addr 0xc2 i2c-bus ivtv i2c driver #1 ivtv1: i2c attach to card #1 ok [client=(tuner unset), addr=61] tda9885/6/7: (ivtv) chip found @ 0x86 ivtv1: i2c attach to card #1 ok [client=tda9887, addr=43] ivtv1: This is the first unit of a PVR500 cx25840 2-0044: cx25843-23 found @ 0x88 (ivtv i2c driver #1) cx25840 2-0044: loaded /lib/modules/HcwMakoA.ROM firmware (14264 bytes) ivtv1: i2c attach to card #1 ok [client=cx25840, addr=44] wm8775 2-001b: chip found @ 0x36 (ivtv i2c driver #1) ivtv1: i2c attach to card #1 ok [client=wm8775, addr=1b] ivtv1: Detected a TEA5767 radio tuner. Enabling radio support. ivtv1: loading /lib/modules/ivtv-fw-enc.bin ivtv1: Encoder revision: 0x02040011 ivtv1: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB total) ivtv1: Allocate DMA encoder YUV stream: 161 x 12960 buffers (2048KB total) ivtv1: Allocate DMA encoder VBI stream: 80 x 26208 buffers (2048KB total) ivtv1: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers (2048KB total) ivtv1: Create encoder radio stream tuner: type set to 56 (Philips PAL/SECAM multi (FQ1216AME MK4)) by ivtv i2c driver #1 ivtv1: Initialized WinTV PVR 500 (unit #1), card #1 ivtv: ====================== NEXT CARD ====================== ivtv2: Autodetected WinTV PVR 150 card (iTVC16 based) ACPI: PCI interrupt 0000:03:09.0[A] -> GSI 22 (level, low) -> IRQ 22 tveeprom: Second (radio) tuner idx 101 tveeprom: ivtv version tveeprom: Hauppauge: model = 23559, rev = D591, serial# = 2989473 tveeprom: tuner = Philips FQ1216AME MK4 (idx = 91, type = 56) tveeprom: tuner fmt = PAL(B/G) PAL(I) SECAM(L/L') PAL(D/K) (eeprom = 0x74, v4l2 = 0x00400e17) tveeprom: audio processor = CX25843 (type = 25) tveeprom: decoder processor = CX25843 (type = 1e) ivtv2: i2c attach to card #2 ok [client=tveeprom, addr=50] tuner (ivtv): chip found at addr 0xc2 i2c-bus ivtv i2c driver #2 ivtv2: i2c attach to card #2 ok [client=(tuner unset), addr=61] tda9885/6/7: (ivtv) chip found @ 0x86 ivtv2: i2c attach to card #2 ok [client=tda9887, addr=43] cx25840 3-0044: cx25843-23 found @ 0x88 (ivtv i2c driver #2) cx25840 3-0044: loaded /lib/modules/HcwMakoA.ROM firmware (14264 bytes) ivtv2: i2c attach to card #2 ok [client=cx25840, addr=44] wm8775 3-001b: chip found @ 0x36 (ivtv i2c driver #2) ivtv2: i2c attach to card #2 ok [client=wm8775, addr=1b] ivtv2: This is the second unit of a PVR500 ivtv2: Correcting tveeprom data: no radio present on second unit ivtv2: loading /lib/modules/ivtv-fw-enc.bin ivtv2: Encoder revision: 0x02040011 ivtv2: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB total) ivtv2: Allocate DMA encoder YUV stream: 161 x 12960 buffers (2048KB total) ivtv2: Allocate DMA encoder VBI stream: 80 x 26208 buffers (2048KB total) ivtv2: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers (2048KB total) tuner: type set to 56 (Philips PAL/SECAM multi (FQ1216AME MK4)) by ivtv i2c driver #2 ivtv2: Initialized WinTV PVR 500 (unit #2), card #2 ivtv: ==================== END INIT IVTV ==================== _______________________________________________ ivtv-devel mailing list [email protected] http://ivtvdriver.org/mailman/listinfo/ivtv-devel
