Hi, Are these messages at the end important? Is there some sort of module option that would help?
Linux video capture interface: v1.00 ivtv: ==================== START INIT IVTV ==================== ivtv: version 0.4.0 (tagged release) loading ivtv: Linux version: 2.6.14-gentoo-r2 preempt K7 gcc-3.3 ivtv: In case of problems please include the debug info ivtv: between the START INIT IVTV and END INIT IVTV lines when ivtv: mailing the ivtv-devel mailinglist. ivtv0: Autodetected WinTV PVR 150 card (iTVC16 based) ACPI: PCI Interrupt Link [LNK1] enabled at IRQ 11 ACPI: PCI Interrupt 0000:01:0a.0[A] -> Link [LNK1] -> GSI 11 (level, low) -> IRQ 11 ivtv0: Unreasonably low latency timer, setting to 64 (was 32) tveeprom: ivtv version tveeprom: Hauppauge: model = 26032, rev = C199, serial# = 2978579 tveeprom: tuner = TCL 2002N 5H (idx = 99, type = 50) tveeprom: tuner fmt = NTSC(M) (eeprom = 0x08, v4l2 = 0x00001000) tveeprom: audio processor = CX25841 (type = 23) tveeprom: decoder processor = CX25841 (type = 1c) ivtv0: i2c attach to card #0 ok [client=tveeprom, addr=50] tuner (ivtv): chip found at addr 0xc2 i2c-bus ivtv i2c driver #0 ivtv0: i2c attach to card #0 ok [client=(tuner unset), addr=61] cx25840 2-0044: cx25841-23 found @ 0x88 (ivtv i2c driver #0) cx25840 2-0044: loaded /lib/modules/HcwMakoA.ROM firmware (14264 bytes) ivtv0: i2c attach to card #0 ok [client=cx25840, addr=44] wm8775 2-001b: chip found @ 0x36 (ivtv i2c driver #0) ivtv0: i2c attach to card #0 ok [client=wm8775, addr=1b] ivtv0: loading /lib/modules/ivtv-fw-enc.bin ivtv0: Encoder revision: 0x02050032 ivtv0: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB total) ivtv0: Allocate DMA encoder YUV stream: 194 x 10800 buffers (2048KB total) ivtv0: Allocate DMA encoder VBI stream: 120 x 17472 buffers (2048KB total) ivtv0: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers (2048KB total) tuner: type set to 50 (TCL 2002N) by ivtv i2c driver #0 ivtv0: Initialized WinTV PVR 150, card #0 ivtv: ==================== END INIT IVTV ==================== ivtv0 warning: ENC: REG_DMAXFER 2 wait failed ivtv0 warning: DEC: REG_ENCSG1LEN wait failed thanks, Mark _______________________________________________ ivtv-devel mailing list [email protected] http://ivtvdriver.org/mailman/listinfo/ivtv-devel
