On Thursday 14 August 2008 21:41:23 jaakko tuomainen wrote:
> Hi,
>
> I have Avermedia C755 video capture card installed
> in my Fujitsu Siemens Activy Media Center 570
> It has two analog video inputs (the first is in front
> panel and the other is the scart connector)
> (front has s-video, rca-plugs for video and stereo audio)
> You can see used chips in dmesg info.
> I haven't tested yet if the video input works already.
Hi Jaakko,
In order to add this card to the supported list I need to have more
information:
- a list of the chips on the board.
- if possible a few good photos of the board, in such a way so that the
text on the chips is readable (not always possible, though).
With this info I can make an initial card definition and then I will
need your help to test that card definition.
Regards,
Hans
>
> Jaakko Tuomainen
>
> lspci
> 01:03.0 Multimedia video controller: Internext Compression Inc iTVC16
> (CX23416) MPEG-2 Encoder (rev 01)
> Subsystem: Avermedia Technologies Inc Device c5ff
> Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop-
> ParErr- Stepping- SERR- FastB2B- DisINTx-
> Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort-
> <TAbort- <MAbort- >SERR- <PERR- INTx-
> Latency: 64 (32000ns min, 2000ns max), Cache Line Size: 32 bytes
> Interrupt: pin A routed to IRQ 18
> Region 0: Memory at f8000000 (32-bit, prefetchable) [size=64M]
> Capabilities: [44] Power Management version 2
> Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA
> PME(D0-,D1-,D2-,D3hot-,D3cold-)
> Status: D0 PME-Enable- DSel=0 DScale=0 PME-
> Kernel driver in use: ivtv
> Kernel modules: ivtv
>
> dmesg | grep ivtv
> ivtv: Start initialization, version 1.2.0
> ivtv0: Initializing card #0
> ivtv0: Unknown card: vendor/device: 4444/0016
> ivtv0: subsystem vendor/device: 1461/c5ff
> ivtv0: cx23416 based
> ivtv0: Defaulting to Hauppauge WinTV PVR-150 card
> ivtv0: Please mail the vendor/device and subsystem vendor/device IDs
> and what kind of
> ivtv0: card you have to the ivtv-devel mailinglist
> (www.ivtvdriver.org) ivtv0: Prefix your subject line with [UNKNOWN
> IVTV CARD].
> ivtv0: Unreasonably low latency timer, setting to 64 (was 32)
> ivtv0: Invalid EEPROM
> cx25840 1-0044: cx25841-23 found @ 0x88 (ivtv i2c driver #0)
> wm8775 1-001b: chip found @ 0x36 (ivtv i2c driver #0)
> ivtv0: Registered device video0 for encoder MPG (4096 kB)
> ivtv0: Registered device video32 for encoder YUV (2048 kB)
> ivtv0: Registered device vbi0 for encoder VBI (1024 kB)
> ivtv0: Registered device video24 for encoder PCM (320 kB)
> ivtv0: Registered device radio0 for encoder radio
> ivtv0: Initialized card #0: Hauppauge WinTV PVR-150
> ivtv: End initialization
> ivtv0: Loaded v4l-cx2341x-enc.fw firmware (376836 bytes)
> ivtv0: Encoder revision: 0x02060039
_______________________________________________
ivtv-devel mailing list
[email protected]
http://ivtvdriver.org/mailman/listinfo/ivtv-devel
