I've got a system (KnoppMyth R5A16) with ivtv 3.6y runnign a pvr-350
and a pvr-150 and I'm seeing periodic messages to /var/log/messages
of the form
Jul 13 11:00:02 mythtvbox kernel: ivtv: Sliced VBI not supported for
cx25840 so no vbi re-insertion possible yet
Jul 13 11:00:02 mythtvbox kernel: ivtv: Allocate DMA encoder MPEG
stream: 128 x 32768 buffers (4096KB total)
Jul 13 11:00:02 mythtvbox kernel: ivtv: Setup VBI API header
0x0000bd0c pkts 1 buffs 48 ln 2 sz 64
Jul 13 11:00:02 mythtvbox kernel: ivtv: Setup VBI start 0x0018ea04
frames 48 fpi 1 lines 0x00000140
is there something I seem to have not done/set properly? I have been
struggling with getting these two tuners going this week. I do seem
to be seeing a couple of these sequences at the end of the dmesg
output:
saa7115: decoder set picture bright=127 contrast=63 saturation=63 hue=0
saa7115: decoder set picture bright=127 contrast=63 saturation=63 hue=0
saa7115: decoder set picture bright=127 contrast=63 saturation=63 hue=0
saa7115: decoder set picture bright=127 contrast=63 saturation=63 hue=0
saa7115: decoder disable output
saa7115: decoder enable output
ivtv: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB total)
ivtv: Allocate DMA encoder VBI stream: 240 x 8736 buffers (2048KB total)
ivtv: Setup VBI API header 0x0000bd06 pkts 1 buffs 48 ln 2 sz 64
ivtv: Setup VBI start 0x0018ea04 frames 48 fpi 1 lines 0x000000f1
saa7115: decoder disable output
saa7115: decoder enable output
ivtv: VBI insertion started
ivtv: close stopping embedded VBI capture
ivtv section from dmesg follows:
ivtv: ==================== START INIT IVTV ====================
ivtv: version 0.3.6 (y) loading
ivtv: Linux version: 2.6.11.9-chw-2 SMP preempt 586 gcc-3.3
ivtv: In case of problems please include the debug info
ivtv: between the START INIT IVTV and END INIT IVTV lines when
ivtv: mailing the ivtv-devel mailinglist.
ivtv: Autodetected WinTV PVR 150 card
ivtv: Found an iTVC16 based chip
ACPI: PCI Interrupt Link [LNK4] enabled at IRQ 5
ACPI: PCI interrupt 0000:01:07.0[A] -> GSI 5 (level, low) -> IRQ 5
ivtv: Unreasonably low latency timer, setting to 64 (was 32)
ivtv: XXX PCI device: 0x01e0 vendor: 0x10de
tveeprom: Hauppauge: model = 26032, rev = C199, serial# = 8002732
tveeprom: tuner = TCL 2002N 5H (idx = 99, type = 50)
tveeprom: tuner fmt = NTSC(M) (eeprom = 0x08, v4l2 = 0x00001000)
tveeprom: audio_processor = TDA9850 (type = 3)
ivtv: i2c attach [client=tveeprom[50],ok]
ivtv: i2c attach [client=(tuner unset),ok]
tuner 2-0061: chip found @ 0xc2 (ivtv i2c driver #0)
saa7115: starting probe for adapter ivtv i2c driver #0 (0x10005)
ivtv: Tuner Type 50, Tuner formats 0x00001000, Radio: yes, Model
0x008d1659, Revision 0x00000000
ivtv: NTSC tuner detected
ivtv: Radio detected
cx25840: starting probe for adapter ivtv i2c driver #0 (0x10005)
cx25840: detecting cx25840 client on address 0x88
cx25840: cx25841-23 found. Initializing...
cx25840: requesting /lib/modules/HcwMakoA.ROM
cx25840: firmware loaded
ivtv: i2c attach [client=cx25840[50],ok]
ivtv: i2c attach [client=wm8775[50],ok]
ivtv: Encoder revision: 0x02040011
ivtv: Configuring WinTV PVR 150 card with 5 streams
ivtv: Registered v4l2 device for encoder MPEG minor 0
ivtv: Create DMA encoder MPEG stream: 0 x 32768 buffers (0KB total)
ivtv: Registered v4l2 device for encoder YUV minor 32
ivtv: Create DMA encoder YUV stream: 0 x 10800 buffers (0KB total)
ivtv: Registered v4l2 device for encoder VBI minor 224
ivtv: Create DMA encoder VBI stream: 0 x 8736 buffers (0KB total)
ivtv: Registered v4l2 device for encoder PCM audio minor 24
ivtv: Create DMA encoder PCM audio stream: 0 x 4608 buffers (0KB total)
ivtv: Registered v4l2 device for encoder radio minor 64
ivtv: Create encoder radio stream
ivtv: Setting Tuner 50
tuner 2-0061: type set to 50 (TCL 2002N)
cx25840: decoder set norm NTSC
cx25840: decoder set input (6)
cx25840: now setting Tuner input
cx25840: set audio input (0)
ivtv: Switching standard to NTSC.
cx25840: decoder set norm NTSC
ivtv: Initialized WinTV PVR 150, card #0
ivtv: Autodetected WinTV PVR 350 card
ivtv: Found an iTVC15 based chip
ACPI: PCI Interrupt Link [LNK3] enabled at IRQ 11
ACPI: PCI interrupt 0000:01:08.0[A] -> GSI 11 (level, low) -> IRQ 11
ivtv: Unreasonably low latency timer, setting to 64 (was 32)
ivtv: XXX PCI device: 0x01e0 vendor: 0x10de
tveeprom: Hauppauge: model = 48132, rev = K168, serial# = 2947528
tveeprom: tuner = LG TAPE H001F MK3 (idx = 68, type = 47)
tveeprom: tuner fmt = NTSC(M) (eeprom = 0x08, v4l2 = 0x00001000)
tveeprom: audio_processor = MSP3440 (type = 11)
ivtv: i2c attach [client=tveeprom[50],ok]
ivtv: i2c attach [client=(tuner unset),ok]
tuner 3-0061: chip found @ 0xc2 (ivtv i2c driver #1)
msp34xx: ivtv version
msp34xx: init: chip=MSP3448W-A2, has NICAM support, simple (D) mode,
simpler (G) no-thread mode
msp34xx: $Id$ compiled on: Jul 10 2005 12:26:39
ivtv: ivtv_enc_thread: pid = 2202, itv = 0xf91f3620
ivtv: ivtv_enc_vbi_thread: pid = 2203, itv = 0xf91f3620
ivtv: i2c attach [client=MSP3448W-A2,ok]
saa7115: starting probe for adapter ivtv i2c driver #1 (0x10005)
saa7115: detecting saa7115 client on address 0x42
saa7115: writing init values
ivtv: i2c attach [client=saa7115[50],ok]
saa7115: status: (1E) 0x48, (1F) 0xc0
cx25840: starting probe for adapter ivtv i2c driver #1 (0x10005)
cx25840: detecting cx25840 client on address 0x88
cx25840: cx25840 not found
ivtv: Tuner Type 47, Tuner formats 0x00001000, Radio: yes, Model
0x00ad1598, Revision 0x00000001
ivtv: Radio detected
saa7127: Ignoring new-style parameters in presence of obsolete ones
saa7127: video encoder driver version V 0.3 loaded
saa7127: detecting saa7127 client on address 0x88
saa7127: Selecting NTSC video Standard
saa7127: Selecting S-Video+Composite
saa7127: Turn WSS off
saa7127: Widescreen Mode 4:3 Full Format
saa7127: Selecting Normal Encoder Input
saa7127: Enable Video Output
ivtv: i2c attach [client=saa7127[50],ok]
ivtv: Encoder revision: 0x02040011
ivtv: Decoder revision: 0x02020023
ivtv: Configuring WinTV PVR 350 card with 10 streams
ivtv: Registered v4l2 device for encoder MPEG minor 1
ivtv: Create DMA encoder MPEG stream: 0 x 32768 buffers (0KB total)
ivtv: Registered v4l2 device for encoder YUV minor 33
ivtv: Create DMA encoder YUV stream: 0 x 10800 buffers (0KB total)
ivtv: Registered v4l2 device for encoder VBI minor 225
ivtv: Create DMA encoder VBI stream: 0 x 8736 buffers (0KB total)
ivtv: Registered v4l2 device for encoder PCM audio minor 25
ivtv: Create DMA encoder PCM audio stream: 0 x 4608 buffers (0KB total)
ivtv: Registered v4l2 device for encoder radio minor 65
ivtv: Create encoder radio stream
ivtv: Registered v4l2 device for decoder MPEG minor 17
ivtv: Create DMA decoder MPEG stream: 0 x 65536 buffers (0KB total)
ivtv: Registered v4l2 device for decoder VBI minor 229
ivtv: Create DMA decoder VBI stream: 0 x 2048 buffers (0KB total)
ivtv: Registered v4l2 device for decoder VOUT minor 233
ivtv: Create decoder VOUT stream
ivtv: Registered v4l2 device for decoder YUV minor 49
ivtv: Create DMA decoder YUV stream: 0 x 43200 buffers (0KB total)
ivtv: Create DMA decoder OSD stream: 0 x 65536 buffers (0KB total)
ivtv: Setting Tuner 47
tuner 3-0061: type set to 47 (LG NTSC (TAPE series))
saa7115: decoder set norm NTSC
saa7115: set audio: 0x01
saa7115: decoder set input (4)
saa7115: now setting Composite input
ivtv: Setting audio matrix to input 3, output 1
ivtv: Switching standard to NTSC.
ivtv: ivtv_enc_thread: pid = 2297, itv = 0xf9216a1c
ivtv: ivtv_enc_vbi_thread: pid = 2298, itv = 0xf9216a1c
ivtv: ivtv_dec_thread: pid = 2299, itv = 0xf9216a1c
ivtv: ivtv_dec_vbi_thread: pid = 2300, itv = 0xf9216a1c
saa7115: decoder set norm NTSC
saa7115: set audio: 0x01
saa7127: Setting Encoder Video Standard
saa7127: Set NTSC Video Mode
saa7127: Selecting NTSC video Standard
ivtv: Initialized WinTV PVR 350, card #1
ivtv: ==================== END INIT IVTV ====================
-------------------------------------------------------
This SF.Net email is sponsored by the 'Do More With Dual!' webinar happening
July 14 at 8am PDT/11am EDT. We invite you to explore the latest in dual
core and dual graphics technology at this free one hour event hosted by HP,
AMD, and NVIDIA. To register visit http://www.hp.com/go/dualwebinar
_______________________________________________
ivtv-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/ivtv-devel
