Thanks for the help. I'm sorry I was not clear enough. This is the senario:
1. PC is off. 2. Turn PC on and run dmesg | grep ivtv and find both 150's are loaded just fine. MythTv works great too. 3. Issue reboot command. When system WARM boots, run dmesg and find 150's are seen as 250's but errors keep MythTV from working. 4. Issue reboot command. When system WARM boots, run dmesg and find 150's are seen as 150's, no errors, MythTV works great. Like clockwork every other WARM boot works. While EVERY cold boot works. Is there a register flush command? I suspect that if I could conditionally load the firmware it would work every time. Something like this pseudo code IF /dev/video0 and /dev/video1 THEN EXIT ELSE (load firmware) Again thanks for the quick replys -Chris ----- Original Message ----- From: "David Novick" <[EMAIL PROTECTED]> To: "User discussion about IVTV" <[email protected]> Sent: Monday, March 06, 2006 8:37 AM Subject: Re: [ivtv-users] PVR150 > > I boot once and everything works fine. Reboot and the two 150's are detected > > as 250's and nothing works. > > When you say reboot, I assume you mean warm reboot and not a shutdown and wait > at least 30 seconds (cold boot) as per the ivtv troubleshooting page? > > Cold boot > > * Shutdown your machine and wait at least 30 seconds. The reason for this > is that registers take a long time to clear. This is especially important when > changing driver versions. > > > David Novick > [EMAIL PROTECTED] > > __________________________________________________ > Do You Yahoo!? > Tired of spam? Yahoo! Mail has the best spam protection around > http://mail.yahoo.com > > _______________________________________________ > ivtv-users mailing list > [email protected] > http://ivtvdriver.org/mailman/listinfo/ivtv-users _______________________________________________ ivtv-users mailing list [email protected] http://ivtvdriver.org/mailman/listinfo/ivtv-users
