I feared you will say this. :-(
Thanks, Peter John Drescher schrieb am 16.07.2006 06:53: > I don't think so. The VIA KM400 and hauppage cards do not play well > together. You can try messing with > dma, pci bus and irq settings in your bios however I was not able to get > my KM400 board to work with my > hauppage 500 card for more than a few seconds before the spontaneous > reboot... My soultion was to get > a new system (AMD64) and after installing my hauppage 500 in the my dual > processor opteron box I have > never had any of these problems again... > > John > > On 7/15/06, * Peter Pramberger* <[EMAIL PROTECTED] > <mailto:[EMAIL PROTECTED]>> wrote: > > Hi all! > > Yesterday I got my new PVR500, put it in my barebone (Athlon XP, VIA > KM400 > running CentOS 4.3) and installed the driver (0.4.6, latest firmware > and no > module options). After reboot ivtv has been loaded and dmesg output > looks ok. > > I can set both tuners using ivtv-tune, and even "cat /dev/video0 > > test.mpg". > But trying any other output - peng, the system freezes within 2 > seconds. Power > management has been disabled, as in the docs - no difference. > > > ivtv-detect: > > driver: ivtv-0.4.6 (tagged release) > card: WinTV PVR 500 (unit #1), bus info 0000:02:08.0, ivtv card #0 > hardware: cx25840 tda9887 wm8775 tveeprom > /dev/video0: MPG encoding (links: /dev/video) > /dev/radio0: Radio (links: /dev/radio) > /dev/vbi0: VBI encoding (links: /dev/vbi) > /dev/video24: PCM encoding > /dev/video32: YUV encoding > > driver: ivtv-0.4.6 (tagged release) > card: WinTV PVR 500 (unit #2), bus info 0000:02:09.0, ivtv card #1 > hardware: cx25840 tda9887 wm8775 tveeprom > /dev/video1: MPG encoding > /dev/vbi1: VBI encoding > /dev/video25: PCM encoding > /dev/video33: YUV encoding > > > dmesg: > > Linux video capture interface: v1.00 > ivtv: ==================== START INIT IVTV ==================== > ivtv: version 0.4.6 (tagged release) loading > ivtv: Linux version: 2.6.9-34.0.2.EL 686 REGPARM 4KSTACKS gcc-3.4 > ivtv: In case of problems please include the debug info between > ivtv: the START INIT IVTV and END INIT IVTV lines, along with > ivtv: any module options, when mailing the ivtv-users mailinglist. > ivtv0: Autodetected WinTV PVR 150 card (cx23416 based) > ivtv0: Unreasonably low latency timer, setting to 64 (was 32) > tveeprom: Second (radio) tuner idx 101 > tveeprom: ivtv version > tveeprom: Hauppauge: model = 23559, rev = D596, serial# = 8859616 > tveeprom: tuner = Samsung TCPG 6221P30A (idx = 96, type = 69) > tveeprom: tuner fmt = PAL(B/G) PAL(I) SECAM(L/L') PAL(D/K) (eeprom = > 0x74, > v4l2 = 0x00400e17) > tveeprom: audio processor = CX25843 (type = 25) > tveeprom: decoder processor = CX25843 (type = 1e) > ivtv0: i2c attach to card #0 ok [client=tveeprom, addr=50] > ivtv0: This is the first unit of a PVR500 > tuner (ivtv): chip found at addr 0xc0 i2c-bus ivtv i2c driver #0 > TEA5767 detected. > ivtv0: i2c attach to card #0 ok [client=(tuner unset), addr=60] > tuner: type set to 62 (Philips TEA5767HN FM Radio) by autodetect > type set to 62 (Philips TEA5767HN FM Radio) > tuner (ivtv): chip found at addr 0xc2 i2c-bus ivtv i2c driver #0 > ivtv0: i2c attach to card #0 ok [client=(tuner unset), addr=61] > cx25840 0-0044: ivtv driver > cx25840 0-0044: cx25843-23 found @ 0x88 (ivtv i2c driver #0) > cx25840 0-0044: loaded v4l-cx25840.fw firmware (16382 bytes) > ivtv0: i2c attach to card #0 ok [client=cx25840, addr=44] > wm8775 0-001b: ivtv driver > wm8775 0-001b: chip found @ 0x36 (ivtv i2c driver #0) > ivtv0: i2c attach to card #0 ok [client=wm8775, addr=1b] > tda9887 0-0043: (ivtv) chip found @ 0x86 (ivtv i2c driver #0) > ivtv0: i2c attach to card #0 ok [client=tda9887, addr=43] > ivtv0: Detected a TEA5767 radio tuner. Enabling radio support. > ivtv0: loaded v4l-cx2341x-enc.fw firmware (262144 bytes) > ivtv0: Encoder revision: 0x02050032 > ivtv0: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB > total) > ivtv0: Allocate DMA encoder YUV stream: 161 x 12960 buffers (2048KB > total) > ivtv0: Allocate DMA encoder VBI stream: 80 x 26208 buffers (2048KB > total) > ivtv0: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers > (2048KB total) > ivtv0: Create encoder radio stream > tuner: type set to 69 (Samsung TCPG 6221P30A) by ivtv i2c driver #0 > ivtv0: Initialized WinTV PVR 500 (unit #1), card #0 > ivtv: ====================== NEXT CARD ====================== > ivtv1: Autodetected WinTV PVR 150 card (cx23416 based) > ivtv1: Unreasonably low latency timer, setting to 64 (was 32) > tveeprom: Second (radio) tuner idx 101 > tveeprom: ivtv version > tveeprom: Hauppauge: model = 23559, rev = D596, serial# = 8859616 > tveeprom: tuner = Samsung TCPG 6221P30A (idx = 96, type = 69) > tveeprom: tuner fmt = PAL(B/G) PAL(I) SECAM(L/L') PAL(D/K) (eeprom = > 0x74, > v4l2 = 0x00400e17) > tveeprom: audio processor = CX25843 (type = 25) > tveeprom: decoder processor = CX25843 (type = 1e) > ivtv1: i2c attach to card #1 ok [client=tveeprom, addr=50] > tuner (ivtv): chip found at addr 0xc2 i2c-bus ivtv i2c driver #1 > ivtv1: i2c attach to card #1 ok [client=(tuner unset), addr=61] > cx25840 1-0044: ivtv driver > cx25840 1-0044: cx25843-23 found @ 0x88 (ivtv i2c driver #1) > cx25840 1-0044: loaded v4l-cx25840.fw firmware (16382 bytes) > ivtv1: i2c attach to card #1 ok [client=cx25840, addr=44] > wm8775 1-001b: ivtv driver > wm8775 1-001b: chip found @ 0x36 (ivtv i2c driver #1) > ivtv1: i2c attach to card #1 ok [client=wm8775, addr=1b] > tda9887 1-0043: (ivtv) chip found @ 0x86 (ivtv i2c driver #1) > ivtv1: i2c attach to card #1 ok [client=tda9887, addr=43] > ivtv1: This is the second unit of a PVR500 > ivtv1: Correcting tveeprom data: no radio present on second unit > ivtv1: loaded v4l-cx2341x-enc.fw firmware (262144 bytes) > ivtv1: Encoder revision: 0x02050032 > ivtv1: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB > total) > ivtv1: Allocate DMA encoder YUV stream: 161 x 12960 buffers (2048KB > total) > ivtv1: Allocate DMA encoder VBI stream: 80 x 26208 buffers (2048KB > total) > ivtv1: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers > (2048KB total) > tuner: type set to 69 (Samsung TCPG 6221P30A) by ivtv i2c driver #1 > ivtv1: Initialized WinTV PVR 500 (unit #2), card #1 > ivtv: ==================== END INIT IVTV ==================== > > > Today I tried the card in another system (P4, Intel chipset running > FC4 and > ivtv 0.7.0) - everything works as expected. > > Any chance that this is driver or kernel related and not caused by > the VIA > mainboard? > > > Thanks, > Peter > > > _______________________________________________ > ivtv-users mailing list > [email protected] <mailto:[email protected]> > http://ivtvdriver.org/mailman/listinfo/ivtv-users > > > > ------------------------------------------------------------------------ > > _______________________________________________ > ivtv-users mailing list > [email protected] > http://ivtvdriver.org/mailman/listinfo/ivtv-users _______________________________________________ ivtv-users mailing list [email protected] http://ivtvdriver.org/mailman/listinfo/ivtv-users
