On Friday 08 September 2006 20:05, Daniel Parish wrote:
> My pvr-150 is now recognized and I can capture video/audio from the
> s-video port, despite misidentification of the card as a pvr-250 and
> the firmware loading errors in the log file (see below).
It's not misdetected. You DO have a PVR-250. The 150 has completely
differect supporting chips. There is no mistake possible.
The firmware loading errors are actually a bug in the hotplug scripts
(if I remember correctly) and can be ignored.
> The tuner
> appears to be recognized and set properly, but I can't tune with it;
> the channels aren't received properly, but I can see/hear enough to
> know that I am close.
Can you give the output of ivtvctl --log-status? Perhaps that might give
me a clue. The tuner is programmed correctly (I checked against the
datasheet).
Hans
>
> I have verified that the cable is good by hooking it to a tv. I have
> tried the us-cable, us-cable-hrm, us-cable-irc and us-bcast frequency
> tables via ivtv-tune, but but still no luck.
>
> The system info:
>
> Fedora Core 5
> Kernel 2.6.17-1, compiled from kernel org sources using a slightly
> modified FC5 config-2.6.17-1.2157_FC5
> DFI Lanparty NFII Ultra B motherboard with an Athlon 2500+ processor
> Chipset nforce 2
>
> Software -- All installed from source
> ivtv-0.7.0
> Video-Frequencies-0.03
> Video-ivtv-0.13
> Config-IniFiles-2.39
> Latest firmware files installed in /lib/firmware.
>
> Suggestions would be greatly appreciated.
>
> Thanks.
>
> Daniel
>
>
>
> kernel: ivtv: ==================== START INIT IVTV
> ==================== kernel: ivtv: version 0.7.0 (tagged release)
> loading
> kernel: ivtv: Linux version: 2.6.17.6-c1 mod_unload 686 REGPARM
> 4KSTACKS gcc-4.1
> kernel: ivtv: In case of problems please include the debug info
> between kernel: ivtv: the START INIT IVTV and END INIT IVTV lines,
> along with kernel: ivtv: any module options, when mailing the
> ivtv-users mailinglist.
> kernel: ivtv0: Autodetected Hauppauge WinTV PVR-250 card (cx23415
> based) kernel: ACPI: PCI Interrupt 0000:01:09.0[A] -> Link [APC2] ->
> GSI 17 (level, high) -> IRQ 19
> kernel: tuner 2-0061: chip found @ 0xc2 (ivtv i2c driver #0)
> kernel: saa7115 2-0021: saa7115 found @ 0x42 (ivtv i2c driver #0)
> kernel: msp3400 2-0040: MSP3435G-B6 found @ 0x80 (ivtv i2c driver #0)
> kernel: msp3400 2-0040: MSP3435G-B6 supports radio, mode is
> autodetect and autoselect
> kernel: tveeprom 2-0050: Hauppauge model 48011, rev F310, serial#
> 5193118
> kernel: tveeprom 2-0050: tuner model is Philips FI1236 MK2 (idx 10,
> type 2)
> kernel: tveeprom 2-0050: TV standards NTSC(M) (eeprom 0x08)
> kernel: tveeprom 2-0050: audio processor is MSP3435 (idx 10)
> kernel: tveeprom 2-0050: has radio
> kernel: ivtv0: loaded v4l-cx2341x-enc.fw firmware (262144 bytes)
> kernel: ivtv0: loaded v4l-cx2341x-dec.fw firmware (262144 bytes)
> firmware_helper[3109]: Loading of /lib/firmware/v4l-cx2341x-enc.fw
> for ivtv driver failed: No such file or directory
> firmware_helper[3112]: Loading of /lib/firmware/v4l-cx2341x-dec.fw
> for ivtv driver failed: No such file or directory
> kernel: ivtv0: Encoder revision: 0x02050032
> kernel: ivtv0: Decoder revision: 0x02020023
> kernel: ivtv0: Allocate DMA encoder MPEG stream: 128 x 32768 buffers
> (4096KB total)
> kernel: ivtv0: Allocate DMA encoder YUV stream: 194 x 10800 buffers
> (2048KB total)
> kernel: ivtv0: Allocate DMA encoder VBI stream: 120 x 17472 buffers
> (2048KB total)
> kernel: ivtv0: Allocate DMA encoder PCM audio stream: 455 x 4608
> buffers (2048KB total)
> kernel: ivtv0: Create encoder radio stream
> kernel: tuner 2-0061: type set to 2 (Philips NTSC (FI1236,FM1236 and
> compatibles))
> kernel: ivtv0: Initialized Hauppauge WinTV PVR-250, card #0
> kernel: ivtv: ==================== END INIT IVTV
> ====================
_______________________________________________
ivtv-users mailing list
[email protected]
http://ivtvdriver.org/mailman/listinfo/ivtv-users
