Hoi Seb,
> > I've also noticed shields, when plugged, get in contact with 7805 and the > cap above. I think I've respected shield's measures (85mm x 74mm), so it's > not bigger as expected. Do you think these parts could be placed a little > more on the left, to make room for shields ? I will see wat I can do > Please send photos ! And maybe put schematic & PCB under SVN, as a new > shield ? I may need this shield in tutorials (I prefer showing a "pure" > Jaluino breadboard shield, than Styx + Arduino's) This shield for now has no extra led and switches like I see on your arduino shield, should I add at least 1 led and 1 or to switches? > How will you decide whether PWM is for LEDs or motors ? Jumpers ? no selection, no dc motor attached is only led and with dc motor attached led is indication of effective output power > As for motor controller chips, I've tested L293D and SN754410 > (http://sirloon.net/loonaweb/sirblog/driving-dc-motors-with-a-pic-16f8...) > with not so much success. It was for driving an RC tank. I've finally > decided to connect PWM signals directly to RC tank H-bridges (though it > probably damages on-board chip, but that's ok I won't use it...). it is just for testing PWM with a little power (BD139) so directly on a dc motor > Maybe something to plug a buzzer on a PWM channel to play with sounds ? buzzer can be connected on PWM output same as for dc motor it’s a universal PWM output with al little power :-) > > Jaluino medium is doing well ! I did print Styx PCB the wrong way, just > before my holidays, so all expected tutorials have been delayed. I printed > it again, and build it just yesterday. It works ok, I can plug my Arduino > breadboard (see low quality photos). Yeah, I love it, very nice indeed. > > I also planned to start to write documentation. Now we're going with DITA, > I'm ready to write, but don't know where to start !... I know that problem, I am a horrible writer How do i inlude pictures in this message (see pictures in file section) -Greetz Richard --~--~---------~--~----~------------~-------~--~----~ You received this message because you are subscribed to the Google Groups "jallib" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/jallib?hl=en -~----------~----~----~----~------~----~------~--~---
