Hi Rob, Enzo, If it was left out, it was unintentionally. It seems that not all displays require the same (all) init-code. All my mirco-stuff is in storage, but I expect to get it back on my workbench around Christmas. If the issue is still open by then, I'll look into it.
Joep 2009/12/10 Rob Hamerling <[email protected]> > > Enzo, > > Thanks Enzo for reporting. > > > seen wrote: > > Hello everybody, > > > > Today I tried this sample: 16f876a_sht.jal. > > At the beginning I only saw the first and the third line of my the > > 20x4 lcd. > > > > In order to solve this problem, I had to modify, lcd_hd44780_4.jal, > > with the two lines below: > > > > __lcd_write( 0b_0010_1000 ) -- two lines, 5x7 > > delay_10us(4) -- > 37 us > > > > > > It seems this line disappeared with the refacturing of the lcd > libraries. See difference between t731 and 825. Joep? > > Regards, Rob. > > > -- > Rob Hamerling, Vianen, NL (http://www.robh.nl/) > > -- > > You received this message because you are subscribed to the Google Groups > "jallib" group. > To post to this group, send email to [email protected]. > To unsubscribe from this group, send email to > [email protected]<jallib%[email protected]> > . > For more options, visit this group at > http://groups.google.com/group/jallib?hl=en. > > > -- You received this message because you are subscribed to the Google Groups "jallib" group. To post to this group, send email to [email protected]. To unsubscribe from this group, send email to [email protected]. For more options, visit this group at http://groups.google.com/group/jallib?hl=en.
