Hi Rob!

I think the hint is in the programming specification (39687E) on page 5 :


The Configuration Words for these devices are located
at addresses, 300000h through 300007h. These are
implemented as three pairs of volatile memory regis-
ters. Each register is automatically loaded from a copystored at the end of 
program memory.

So, there are the "configuration words", which are RAM and can't be permanently 
programmed. They are loaded on startup with the values found in the "flash 
configuration words", which reside in the last program memory cells. So this is 
the place to use for flashing.

Thanks for all your good work! 

Greets,
Kiste

 



----- Ursprüngliche Message -----
Von: Rob Hamerling <[email protected]>
An: [email protected]
CC: 
Gesendet: 16:12 Mittwoch, 16.Oktober 2013
Betreff: [jallib] fuses addresses


Hi guys,

I'm confused (once again)... Some 18F PICs seem to have 2 address ranges 
for the fuses. For example the 18f24j10 programming specifications 
(39682E) figure 2-2 mentions an address range for "Flash configuration 
words" and another range for "Configuration Words".
The question is: which of these ranges should be specified in the JalV2 
device files (and consequently appear in the hex file)? Can someone 
enlighten me?

Regards, Rob.

-- 
R. Hamerling, Netherlands --- http://www.robh.nl

-- 
You received this message because you are subscribed to the Google Groups 
"jallib" group.
To unsubscribe from this group and stop receiving emails from it, send an email 
to [email protected].
To post to this group, send email to [email protected].
Visit this group at http://groups.google.com/group/jallib.
For more options, visit https://groups.google.com/groups/opt_out.

-- 
You received this message because you are subscribed to the Google Groups 
"jallib" group.
To unsubscribe from this group and stop receiving emails from it, send an email 
to [email protected].
To post to this group, send email to [email protected].
Visit this group at http://groups.google.com/group/jallib.
For more options, visit https://groups.google.com/groups/opt_out.

Reply via email to