Emmanuel,
I don't see anything off-hand in the James CVS that would cause a change in
that behavior. What I do see is that James will verify in AUTH, but since
you have VERIF turned on, it will also verify that the MAIL FROM sender is
the same as the identity used with AUTH. Check your mail client config.
But I don't see anything that would cause James to verify authentication
using the recipient ID. Can you post a section of the log showing that
transaction?
--- Noel
-----Original Message-----
From: Emmanuel Gilmont [mailto:[EMAIL PROTECTED]
Sent: Friday, March 14, 2003 12:33
To: [EMAIL PROTECTED]
Subject: Problem with AUTH in James 2.1.2
Hello guys,
I use James 2.1.2 with AUTH and VERIF enabled for the SMTP protocol.
Here is my problem: when I send a mail from my lan to someone not recorded
in
my James sever, James spool and send the mail with no error. When I do the
same from the Internet (so, outside my lan), I receive an error. When I look
inside the smtp log file (with debug), I see James does an AUTH verification
on the sender and sends OK, *but* does also an AUTH verification on the
receiver of the mail... and thus sends a not OK response (code 530).
For what I remember, this was not the case with version 2.1
I don't understand why.
If anybody has an idea, it will be cool...
Thanks,
Emmanuel
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
