Hi,
I have following requirement
Value Match Extent
Fieldname1 c1 23
Fieldname2 c2 26
Filedname3 c8 85
Can I use lucene for the same. If yes what is easiest and the best way to use.
Regards,
Allahbaksh
Allahbaksh Mohammedali Asadullah,
Software Engineering & Technology Labs,
Infosys Technolgies Limited, Electronics City,
Hosur Road, Bangalore 560 100, India.
*Board: +91-80-28520261 | Extn: 53915 | Direct: 41173915.
Fax: +91-80-28520362 | Mobile: +91-9845505322.
[cid:[email protected]]
**************** CAUTION - Disclaimer *****************
This e-mail contains PRIVILEGED AND CONFIDENTIAL INFORMATION intended solely
for the use of the addressee(s). If you are not the intended recipient, please
notify the sender by e-mail and delete the original message. Further, you are
not to copy, disclose, or distribute this e-mail or its contents to any other
person and any such actions are unlawful. This e-mail may contain viruses.
Infosys has taken every reasonable precaution to minimize this risk, but is not
liable for any damage you may sustain as a result of any virus in this e-mail.
You should carry out your own virus checks before opening the e-mail or
attachment. Infosys reserves the right to monitor and review the content of all
messages sent to or from this e-mail address. Messages sent to or from this
e-mail address may be stored on the Infosys e-mail system.
***INFOSYS******** End of Disclaimer ********INFOSYS***
