Aaah thanks,
It hadn't occured to me to use an inner while loop to make sure the last
test element was in fact the last one for a given thread. That should just
about do what I need it to do.
Thanks again,
Vince
sebb <[EMAIL PROTECTED]>
05/18/2005 07:30 PM
Please respond to "JMeter Users List"
To: JMeter Users List <jmeter-user@jakarta.apache.org>
cc:
Subject: Re: Capturing a threadgroup's end of execution
At present I don't think there is any communication possible between
different thread groups - apart from properties, which are shared.
One way to achieve what you want would be to set a property in one
group and test it in the other.
The latest CVS code has a property setting function.
Or you can use BeanShell (have a look at the .bshrc files) to set the
property.
Your first group would need to have a structure like so:
Thread Group (once only)
- Loop Controller (as many times as needed)
- Some element to set the property, e.g. BeanShell Sampler. This would
generate an extra sample.
S.
On 5/18/05, [EMAIL PROTECTED] <[EMAIL PROTECTED]> wrote:
> Basically, I have a test plan that has two thread groups in it.
>
> The two groups need to perform their operations concurrently, however,
the
> second group must run for as long as the first one is running (the run
> time of the first group SHOULD NOT vary much but it is not outside the
> realm of the reasonable to believe that it COULD vary so it isn't
entirely
> predictable). Once the first group ends, the second one must perform a
> given operation and then also finish.
>
> I was looking for an appropriate trigger to signal the end of a thread
> group's execution.
>
> I looked into the conditions under which the testEnded method gets
called
> in TestListeners and as far as I can discern, each time a thread is
ended,
> the engine checks if this is the last test thread remaining over all
> (including all thread groups) and if it is, the test is considered
ended.
> So it doesn't seem like the threads, once started, have any recollection
> of belonging to a given threadgroup (right?). So it's entirely possible
> that there is no such way of tracking the end of all the threads in a
> given group, I just wanted to see if that was accurate.
>
> Vince
>
>
>
>
>
>
> sebb <[EMAIL PROTECTED]>
> 05/18/2005 02:27 PM
> Please respond to "JMeter Users List"
>
>
> To: JMeter Users List <jmeter-user@jakarta.apache.org>
> cc:
> Subject: Re: Capturing a threadgroup's end of execution
>
>
>
> Just wondering - why do you need to do this?
>
>
> S.
> On 5/18/05, [EMAIL PROTECTED] <[EMAIL PROTECTED]> wrote:
> > Hello,
> >
> > I was wondering if there was a way in JMeter to identify when all the
> > threads of a given ThreadGroup have finished executing (a bit like
> > implementing the TestListener interface allows you to know when an
> entire
> > test ends). If there is no straightforward way of doing this is there
a
> > circuitous way?
> >
> > Thanks in advance,
> > Vince
> >
>
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: [EMAIL PROTECTED]
> For additional commands, e-mail: [EMAIL PROTECTED]
>
>
>
>
>
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
