Hi all, Our JMeter testing platform consists of 7 PCs - one controller and 6 running Jmeter servers that we use for load generation. Many of the tests we run are stress tests - where we gradually increase the load over time to establish system capacity and breaking points. We use the JMeter "Ramp-Up Period" setting to give this testing profile. This works fine when only running on a single PC, however, we have issues running these types of tests spread across our remote PCs.
For example if we want to run a test with 60 threads, we have a thread group with 10 threads on our controller, and then start the test running remotely on the six load generators. In this scenario, if we use a ramp up, the load is increased in steps of 6 threads, rather than gradually 1 thread at a time as we would like. Can anyone suggest any way for use to get round this issue while still using remote JMeter servers? Perhaps this is changed in a new version? We are currently using 2.3RC4 and I've reviewed the release notes for later versions but haven't seen anything. Any suggestions would be welcomed! Regards, Adrian ************************ This message has been delivered to the Internet by the Revenue Internet e-mail service (OP) ************************* --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
